RZ 2610001563 07-09:RZ 2610001563 07-09 7/24/09 10:13 AM Page 10
INSTALLING THE SUPPORT STRAP | FIG. 4 |
With the wrench storage pocket facing down, thread the end of the strap opposite the Rotozip® logo through the post near the front of the tool as shown. Continue to thread the strap through the rear post near the cord. Fold the back flap over first (1), then fold the end with the Rotozip® logo (2) as shown in figure 4. Press firmly to ensure the strap is secured.
Operating Instructions
SLIDE
The tool is switched “ON” by the switch button located at the side of the motor housing (Fig. 5). The switch can be locked in the “ON” position, a convenience for long cutting operations.
TO TURN THE TOOL “ON” without locking it, slide the switch button forward by applying pressure ONLY at the REAR portion of the button. When pressure is released the switch button will snap to “OFF” position.
TO LOCK THE SWITCH “ON”, slide the switch button forward and press “IN” the FRONT portion.
TO UNLOCK THE SWITCH, simply press and release the REAR portion of the button. Switch is spring loaded and will snap back automatically.
FIG. 5
FIG. 6