Campbell Hausfeld PW1605, PW1825 Service, Servicing of a Double-Insulated Appliance, Operation

Double Insulated Symbol

Operating Instructions and Parts Manual

Important Safety Information (Continued)

Service

a.When servicing a tool, use only identical replacement parts. Use only authorized parts.

Servicing of a Double-Insulated Appliance

In a double-insulated product,

two systems of insulation are provided instead of grounding. No grounding means are provided for a double-insulated product, nor should grounding means be added to the product. Servicing a double-insulated product requires extreme care and knowledge of the system, and should be done only by qualified service personnel.

Replacement parts for a double-insulated product must be identical to the original parts. A double-insulated product is marked with the words “Double Insulation” or “Double Insulated.” Product may also be marked with symbol shown below.

Save These Instructions — Do Not Discard

NOTE: The DANGER, WARNING, CAUTION, and NOTICE notifications and instructions in this manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into this product, but must be supplied by the operator.

! IMPORTANT !

This pressure washer is equipped with a microswitch sensitive to water flow. This Instant Start/Stop switch (ISS) senses water flow in the pump. When the trigger is released, water stops flowing through the pump. The ISS then automatically turns the motor off to protect pump from overheating.

Operation

1.Pull trigger on gun.

2.Turn the “ON/OFF” switch to “ON”.

3.Release trigger. The pressure washer motor will stop running.

4.To spray again, pull trigger and motor and pump will restart.

Note: Occasionally the motor may run for a short time to bring fresh, cool water into the pump even if trigger is released. This is part of normal operation and will not damage the unit.

Always turn the “ON/OFF” switch

to “OFF” then trigger gun to release hose pressure before unplugging power cord.

Risk of equipment damage. Always make sure the “ON/OFF” switch on the

unit is “OFF” and unit is unplugged prior to storage.

Risk of Injection. Unit will start spraying when trigger is squeezed if

ON/OFF switch is in “ON” position. Always point gun in safe direction.

Call 1-800-330-0712 for Technical Service

6www.chpower.com