ATTACHING DUST BAG
Attach the dust bag (A) Fig. 5 to the dust spout (B) making sure the wire ring (C) is engaged with the ridge in the spout (see inset).
Fig. 5
C 
A
B
FASTENING MACHINE TO SUPPORTING SURFACE
Before operating your compound miter saw, mount it to a sturdy workbench or other supporting surface. Four holes are provided, two of which are shown at (A) Fig. 6.
When frequently moving the saw from place to place, mount the saw to a 3/4”piece of plywood. The tool can then be easily moved from place to place and the plywood can be clamped to a supporting surface using “C” clamps.
A |
Fig. 6 |
OPERATING CONTROLS AND ADJUSTMENTS
TABLE HAZARD AREA
The area inside the two red lines on the table (A) Fig. 7 is designated as a "HAZARD ZONE". Never place your hands inside this area while the machine is running. Maintain hands 6” from blade.
WORK CLAMP
Position the work clamp in one of the two holes (B) Fig 8 in the left or right side of the base. Use this clamp, especially with short workpieces.
Keep your hands out of the path of the saw blade. If necessary, clamp the workpiece in place before making the cut if hands would be within 6” of blade.
A 
Fig. 7
A
B 
Fig. 8
8