HP Web-Based Enterprise Services 4.5 manual OpenVMS Webes Issues

Overall WEBES Release Notes

1.6 WEBES Known Issues

You can safely ignore this message. There is no impact to WEBES or WCCProxy installation or operation.

1.6.4 OpenVMS WEBES Issues

These issues apply to WEBES on OpenVMS:

1.6.4.1Set ODS-5 Attributes Before Issuing WEBES CLI Commands

The following applies only if your system disk or the disk to which you have installed WEBES is an ODS-5 disk.

Before issuing any WEBES CLI command (desta, wsea, wccat, or wccproxy), issue the following command to assign certain ODS-5 settings required for the WEBES command to operate properly:

$ SET PROCESS /CASE=BLIND /PARSE=TRADITIONAL

After completing the WEBES command, you can revert to your previous settings for CASE and PARSE using the above command with different keywords. To find out your current settings before changing them, issue the following command: (partial output shown)

$ SHOW PROCESS /CASE /PARSE { ... }

Parse Style: Traditional

Case Lookup: Blind

This is only an example. Your output may show the "Sensitive" or "Extended" keywords instead.

If you do not issue the above "SET" command, and you have Case-Sensitive or Parse Style Extended settings on your process, WEBES CLI commands will return errors such as the following:

%DCL-E-OPENIN, error opening

_NUTE$DKA0:[sys0.syscommon.hp.svctools.][common.bin]desta.com; as input %DCL-E-OPENIN, error opening _NUTE$DKA0:[sys0.syscommon.hp.svctools.][common.bin]wsea.com; as input %DCL-E-OPENIN, error opening _NUTE$DKA0:[sys0.syscommon.hp.svctools.][common.wccproxy.bin]wccproxy.co m; as input

-RMS-E-DNF, directory not found

-SYSTEM-W-NOSUCHFILE, no such file

WEBES CLI commands on OpenVMS have not yet been developed to be case-sensitive for ODS-5 support.

Rev. 9/8/06

1–22 Web-Based Enterprise Services Release Notes