Samsung VP-D381/XEF, VP-D381/EDC Playback, Playing Back a Tape on the LCD Screen, Lcd螢幕上播放錄影帶

playback

PLAYING BACK A TAPE ON THE LCD SCREEN

播放

在LCD螢幕上播放錄影帶

•The playback function and speaker works only in Player mode. ➥page 18

•You can monitor the playback picture on the LCD screen.

1. Insert the tape you wish to view. ➥page 34

2. Set the Select switch to TAPE. (VP-D385( i ) only)

3. Press the MODE button to set Player ( ).

4. Open the LCD screen.

•Adjust the angle of the LCD screen and set the brightness or colour if necessary. ➥page 31

5.Press the Joystick, then move the Joystick (/) left or right to rewind or forward the tape to the starting point.

•To stop rewinding or forwarding, move down the Joystick ().

•The camcorder stops automatically after rewinding or forwarding is completed.

6.Press the Joystick to start playback.

•You can view the picture you recorded on the LCD screen.

•To stop the play operation, move down the Joystick ().

Adjusting the LCD Bright / LCD Colour during Playback

•You can adjust the LCD bright/LCD colour during playback.

•The adjustment method is the same procedure as used in Camera mode. ➥page 31

Adjusting the Volume

•	When you use the LCD screen for playback, you can
	hear recorded sound from the built-in speaker.
	- Take the following steps to lower the volume or mute the
•	sound while playing a tape on the camcorder.
	When sound is heard once the tape is in play, use the
	Zoom (VOL) lever to adjust the volume.
	- A volume level display will appear on the LCD
	screen.
	- Levels may be adjusted from anywhere between
	"00" to "19".
	- If you close the LCD screen while playing, you will
•	not hear sound from the speaker.
	When the Audio/Video cable is connected to the

CARD TAPE

(VP-D385( i ) only)

SP

MIX[1+2]

12:00 1.JAN.2008

STOP SP

[11]

MODE

BATT.

BATT.

0:00:30:23

60min S 16BIt

AV In

0:00:30:23

60min

•播放功能和喇叭僅可在 Player 模式下操作。 ➥ 第 18 頁

•您可以在 LCD 螢幕上監視播放畫面。

1. 放入您要檢視的錄影帶。 ➥ 第 34 頁

2. 將選擇開關設定為 TAPE。（僅適用於 VP-D385( i ))

3. 按下 MODE 按鈕以設定 Player ( ).

4. 打開 LCD 螢幕。

•調整 LCD 螢幕的角度、如有必要、設定亮度或色 彩。 ➥ 第 31 頁

5. 按下 Joystick、然後向左或向左移動 Joystick (/)

以將錄影帶回轉或前進至起始點。

•以將錄影帶回轉或前進至起始點 Joystick ().

•完成回轉或前進後、攝錄放影機會自動停止。

6. 按下 Joystick 以開始播放。

•您可以在 LCD 螢幕上檢視您所錄製的畫面。

•若要停止播放操作、可向下移動 Joystick ().

在播放期間調整 LCD Bright / LCD 色彩。

•您可以在播放期間調整 LCD bright / LCD 色彩。

•調整方法和在 Camera 模式中使用的程序相同。 ➥ 第 31 頁

調整音量

•當您使用 LCD 螢幕來播放時、您可以從內置喇叭聽到 所錄製的音效。

-在攝錄放影機上播放錄影帶時採取以下步驟來調低 音量或設定靜音。

•當您聽到錄影帶播放的音效時、使用桿來調整音量。縮放 (VOL)

-LCD 螢幕上會出現音量顯示。

-音量可在 "00" 到 "19" 之間進行調整。

-若您在進行播放時關閉 LCD 螢幕、您將不會從 喇叭聽到音效。

•當聲訊 / 視訊纜線連接到攝錄放影機時、您將無法從內 置喇叭聽到音效、同時也不能調整音量。

camcorder, you cannot hear sound from the built-In

speaker and cannot adjust the volume.

62_ English

12:00 1.JAN.2008

MOV_0001

臺灣 _62