Samsung AP50M1ANXSG, AP50M0ANXSG manual Basic operation

Page 14

Basic operation

Basic operation is an operation mode that can be selected by pressing the Mode button.

Auto

In Auto mode, the air conditioner will automatically set the Operation(Cool/Heat Mode) and fan speed depending on the room temperature detected by the room temperature sensor. (Heat mode is applicable to AP50M1✴ model only.)

Cool

Cool mode is frequently used and you can freely control the temperature, fan speed, and air flow direction in cool mode.

Dry

The air conditioner in Dry mode acts like a dehumidifier by removing moisture from the indoor air. The Dry mode will provide you with fresh air even on a rainy day.

ffOutdoor unit will repeatedly and automatically turn on/off for maximum dehumidification according to the temperature difference of the current and desired temperature.

Fan

Fan mode can be selected to ventilate your room. Fan mode will be helpful to refresh the stale air in your room.

fIfyou are not going to use the air conditioner for a while, we recommend to operate the Fan mode for 3~4 hours to dry the internal part of the air conditioner..

Heat (Applicable model: AP50M1✴)

In Heat mode, the indoor temperature, fan speed, and air flow direction can be adjusted at your desire to warm your indoor.

ffIndoor unit may not start the operation immediately until indoor heat exchanger is warmed up to a certain temperature (approximately 5 minutes according to current indoor temperature) to prevent generating a cold breeze.

ffDefrost display: When removing frost at the outdoor unit in the Heat mode, (Defrost) icon will be displayed on the indoor unit display and it will be turned off after removing the frost.

(When removing the frost during the defrost operation in Heat mode, steam may be generated and the warm breeze may not come out from the indoor unit.)

 

 

 

• When the outdoor temperature is low and humidity is high, frost may form on outdoor unit's heat exchanger and

 

 

 

may decrease the heating performance so the Defrost operation will operate for 5 ~ 12 minutes to get rid of the

NOTE

frost on the outdoor unit heat exchanger. Indoor unit will be off during Defrost operation is on since cold air may

 

 

 

 

 

 

come out from it.

-- Intervals between Defrost operation cycle may vary depending on the amount of frost on the outdoor unit. -- In snowy or rainy days, Defrost operation cycle may be shorter due to humidity.

-- You cannot control the air conditioner with the remote controller while Defrost operation is on. Try to control the air conditioner after Defrost operation is complete.

14

Mirage_AP50M0@_IBIM_EN_05323A-02.indd 14

2016-05-19 오후 1:27:13

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Air Conditioner Thank you for purchasing this Samsung productLook for Everywhere Features of your new air conditionerStrong Turbo/Long Function Contents Do not yank the power cable with hands Safety precautionsImportant safety symbols and precautions Ensure no water gets into the air conditioner FfPotential risk of personal injury Use a rated circuit breaker onlyFfPotential risk of injury or electric shock Do not open the front panel during operationFfPotential risk of personal injury or property loss Do not allow children to climb on the air conditionerFfInsufficient ventilation may result in poor performance FfWearing thick gloves can protect your hands Main parts Viewing your air conditionerChecking the indoor unit and display To open the panelControl panel Heater and Purity function is not supported by this modelChecking the remote controller Remote controller buttonsAre in the same space Remote controller displayUsing the remote controller Inserting the batteries Battery changing timeStoring the remote controller Indoor unitBasic operation Adjusting the desired temperature Turning on the powerSelecting the operation mode Selecting the fan speedSelecting air flow direction You cannot set the fan speed when setting the On timer Setting the On/Off timerWhen the air conditioner is off Controller displayWhen the air conditioner is on ButtonUsing the Turbo function When the air conditioner is operating in Cool or Heat modeUsing the Long function Locking the control panelUsing the air conditioner with the control panel Cleaning the filter Air filter Cleaning and maintaining the air conditionerCleaning the exterior Periodical checks Installation partMaintaining your air conditioner Have deposited at low temperatures Internal protections via the unit control systemTroubleshooting AppendixOperation ranges HumidityGeneral information Installing the unitOr accessing its internal components PersonnelMake sure that you earth the cables Power supply line, fuse or circuit breakerDo not install the air conditioner in following places Complete, electric shock or fire may occurAccessory parts list Top view Selection of installation placeIndoor unit Side viewOutdoor unit Ventilate Preparing the installationSelecting appropriate location for installation Space requirements Wear protective goggles and mask before sprayingCord. Code designation IEC60245 IEC 66 / CENELECH07RN-F Wiring standardElectrical work Ssc *2AP50M0 Series Indoor and outdoor connection wiringUsing 4poles ELCBEarth Leakage Circuit Breaker Using 3poles Elcb and 2poles Elcb AP50M1 SeriesElectrical wiring Connecting the power terminalWhen using the rubber leg Installation methodOutdoor unit When using the anchor bolt Installation proceduresTrap Oil trap Check the following list and install an oil trapRefrigerant pipe work Insulating the pipes FfRadius of curvature R on the oil trap are as followsRemove burr on the edge of pipe Cut the pipe using the pipe cutterConnection of refrigerant piping Flare processing It may cause explosion and injuryDrilling a hole in the wall Pipe bendingTightening of connection parts Fixing the indoor unit Wall installation Corner InstallationDrain hose ExampleAir purge Be sure that all valve cocks are closedCheck the stability of the pressure for 10 minutes How to add refrigerantRefrigerant charging Is grounding properly made? Check and test operationCheck Test operation Pump down procedure When removing the productWhen the outdoor temperature is below zero, do not Packing and unpacking guide Outdoor unit Prepare the following tools How to connect your extended power cablesMm of the wire shields of the tube TubeFfMethod Apply heat to the contraction tube to contract itMirageAP50M0@IBIMEN05323A-02.indd 2016-05-19 오후 English Questions or COMMENTS?
Top Page Image Contents