Samsung AP50M1ANXSG, AP50M0ANXSG manual Internal protections via the unit control system

Page 24

Cleaning and maintaining the air conditioner

Internal protections via the unit control system

This internal protection operates if an internal fault occurs in the air conditioner.

Type

Description

 

 

Against cold air

The internal fan will be off to against cold air when the heat pump is heating.

 

 

Defrost cycle

The internal fan will be off to against cold air when the heat pump is heating.

 

 

Protect compressor

The air conditioner does not start operating immediately to protect the compressor of the

outdoor unit after it has been started.

 

 

 

 

If the heat pump is operating in Heat mode, defrost cycle is actuated to remove frost from an outdoor unit that may

 

 

 

have deposited at low temperatures.

NOTE

The internal fan is switched off automatically and restarted only after the defrost cycle is completed.

 

 

 

24

Mirage_AP50M0@_IBIM_EN_05323A-02.indd 24

2016-05-19 오후 1:27:19

Page 23 Page 25
Image 24
Page 23 Page 25
Contents Air Conditioner Thank you for purchasing this Samsung productFeatures of your new air conditioner Strong Turbo/Long FunctionLook for Everywhere Contents Safety precautions Important safety symbols and precautionsDo not yank the power cable with hands Ensure no water gets into the air conditioner Use a rated circuit breaker only FfPotential risk of injury or electric shockFfPotential risk of personal injury Do not open the front panel during operationDo not allow children to climb on the air conditioner FfInsufficient ventilation may result in poor performanceFfPotential risk of personal injury or property loss FfWearing thick gloves can protect your hands Viewing your air conditioner Checking the indoor unit and displayMain parts To open the panelControl panel Heater and Purity function is not supported by this modelChecking the remote controller Remote controller buttonsRemote controller display Using the remote controllerAre in the same space Battery changing time Storing the remote controllerInserting the batteries Indoor unitBasic operation Turning on the power Selecting the operation modeAdjusting the desired temperature Selecting the fan speedSelecting air flow direction Setting the On/Off timer When the air conditioner is offYou cannot set the fan speed when setting the On timer Controller displayWhen the air conditioner is on ButtonUsing the Turbo function When the air conditioner is operating in Cool or Heat modeUsing the Long function Locking the control panelUsing the air conditioner with the control panel Cleaning and maintaining the air conditioner Cleaning the exteriorCleaning the filter Air filter Installation part Maintaining your air conditionerPeriodical checks Have deposited at low temperatures Internal protections via the unit control systemTroubleshooting AppendixOperation ranges HumidityInstalling the unit Or accessing its internal componentsGeneral information PersonnelPower supply line, fuse or circuit breaker Do not install the air conditioner in following placesMake sure that you earth the cables Complete, electric shock or fire may occurAccessory parts list Selection of installation place Indoor unitTop view Side viewOutdoor unit Preparing the installation Selecting appropriate location for installationVentilate Space requirements Wear protective goggles and mask before sprayingWiring standard Electrical workCord. Code designation IEC60245 IEC 66 / CENELECH07RN-F Ssc *2Indoor and outdoor connection wiring Using 4poles ELCBEarth Leakage Circuit BreakerAP50M0 Series Using 3poles Elcb and 2poles Elcb AP50M1 SeriesElectrical wiring Connecting the power terminalInstallation method Outdoor unit When using the anchor boltWhen using the rubber leg Installation proceduresTrap Check the following list and install an oil trap Refrigerant pipe work Insulating the pipesOil trap FfRadius of curvature R on the oil trap are as followsCut the pipe using the pipe cutter Connection of refrigerant piping Flare processingRemove burr on the edge of pipe It may cause explosion and injuryPipe bending Tightening of connection partsDrilling a hole in the wall Wall installation Corner Installation Drain hoseFixing the indoor unit ExampleAir purge Be sure that all valve cocks are closedHow to add refrigerant Refrigerant chargingCheck the stability of the pressure for 10 minutes Check and test operation CheckIs grounding properly made? Pump down procedure When removing the product When the outdoor temperature is below zero, do notTest operation Packing and unpacking guide Outdoor unit How to connect your extended power cables Mm of the wire shields of the tubePrepare the following tools TubeFfMethod Apply heat to the contraction tube to contract itMirageAP50M0@IBIMEN05323A-02.indd 2016-05-19 오후 English Questions or COMMENTS?
Top Page Image Contents