31
DOOR TRIM
LOG PLACEMENT
The BGD42CF comes complete with top door trim
(W715-0729).
1.Guide the arms of the trim into the slots that are slightly hidden under the facing through the open- ing between the top of the door and the bottom edge of the facing as illustrated in the front view.
2.Slide the arm into the slot far enough to allow the front edge of the trim to go in behind the facing.
3.Let the bracket come forward towards the back of the facing and allow the trim to rest on the inside lip, this position will allow the notch on the arm of the trim to fall into place on the edge of the slot.
| SLOT |
FACING | FIGURE 102a |
| TRIM |
DOOR |
|
BGD42CF FRONT VIEW
NOTCH | FIGURE 102b | ||||
INSIDE LIP | S |
|
| ||
|
| E |
| ||
|
|
| E | ||
|
|
|
| - | |
|
|
|
| T | |
|
|
|
| H | |
|
|
|
|
| R |
|
|
|
|
| U |
|
|
|
|
| W |
|
|
|
| I | |
|
| O | D | N |
|
| W |
|
| ||
|
|
|
| ||
|
|
|
|
| |
BGD42CF SIDE VIEW
PHAZERTM logs and glowing embers, exclusive to Napoleon® Fireplaces, provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect. Log colours may vary. During the initial use of the fi replace, the colours will become more uniform as colour pigments burn in during the heat activated curing process.
FIGURE 104
1.Place the cutout in the bottom of log #1 behind the pilot assembly. Rest the log against the back wall of the fi rebox.
FIGURE 105
FIGURE 102c
BGD42CF WITH TOP DOOR TRIM INSTALLED
GRATE INSTALLATION
The grate for this |
| |
fi replace has been | GRATE | |
removed for shipping | ||
purposes. |
| |
The grate must be in- |
| |
stalled before the logs | PINS | |
are installed. | ||
| ||
Remove the packag- |
| |
ing from the grate and |
| |
install onto the two pins |
| |
as illustrated. |
|
FIGURE 103
2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs.
3.Tear the glowing embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct fl ame; however, care should be taken to not block the burner ports. Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZERtm logs glow when exposed to direct fl ame.
FIGURE 106
4.Place the bottom of the left crossover log (#4) onto the stud on the left side of the log support. The top of the log should rest in the pocket on the back log.
FIGURE 107
5.Place the bottom of the right crossover log (#5) onto the stud on the right side of the log support. The top of the log should rest in the pocket on the left crossover log (#4).