30
FINISHING
BGD36CF FINISHING
LOG PLACEMENT
PHAZERTM logs and glowing embers exclusive to Napoleon® Fire- places, provide a unique and realistic glowing effect that is different in every installation. Take the time to carefully position the glowing embers for a maximum glowing effect.
Log colours may vary. During the initial use of the fi replace, Log colours may vary. During the initial use of the fi replace the colours will become more uniform as colour pigments burn in during the heat activated curing process.
FIGURE 93
SIDEVIEW
1.Place the back log (#1) onto the log support tray and in front of the tabs. The tabs maintain an air space between the log and fi rebox back to facilitate combustion air fl ow. Ensure that the back of the log rests against the brackets on the back wall of the fi rebox.
FIGURE 98
5.Place the bottom of the right crossover log (#6) against the right fi rebox side and pulled forward to the grate. The top of the log should rest in the pocket provided on the center log (#5).
BGD36CF(G) GLASS/DOOR REPLACEMENT
1. Place the door frame face down care- | FIGURE99 |
ful not to scratch the paint. |
|
2. Center the gasketed glass inside the door frame with the thick side of the gasket fac- ing up.
3. Bend the glass retainers lo- cated along the edge of the door frame over the gasket holding the glass in place. Careful not to break the glass.
BGD42CF FINISHING
DOOR INSTALLATION / REMOVAL
TAB | FIGURE 94 |
FIGURE 95
2.Move the two small logs (#2 & #3) into position, lining up the studs located on the burner with the holes on the bottom of the logs. Ensure that the small logs sit fl at on the burner.
FIGURE 96
Open the Valve Access Door. While holding the door securely, release the 4 latches along the top of the door.
Tilt the door forward and lift off of the
two brackets at the bottom of the door.
When replacing the door, rest the door on the brackets ensuring that lip of the brackets rest in the groove in the bottom edge of the door. Push the door backward into place and secure with the 4 latches.
FIGURE 100
DOOR BRACKET
3.Place the bottom of the left crossover log (#4) against the left
firebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
FIGURE 97
4.Position the base end of the center log (#5) against the middle grate post with the other end of the log resting in the pocket of the left crossover log.
REMOVING THE VALVE ACCESS DOOR
1.The valve access door rotates on the pins attached to the side frame. Lift the valve access door off the pins to operate
the main glass door.
FIGURE 101
GLASS/DOOR REPLACEMENT
Only available as an assembly complete with frame