Napoleon Fireplaces BGD42CFN Hearth Installation, Optional Clean Face Trim KIT Installation, 37 3

28

HEARTH INSTALLATION

When installing to a hearth the fi replace riser must create a minimum clearance of 3 3/8" PLUS the height of the hearth from the fi nished fl oor to the bottom of the fi replace.

						FIGURE 86b
	STEEL		COMBUSTIBLE			STEEL
			MATERIAL
	HEADER		NON-COMBUSTIBLE			HEADER
STAND-OFF			MATERIAL			STAND-OFF
			6 1/2” MINIMUM
CLEAN FACE SURROUND KIT
			37 3/8”
			PLUS
			HEARTH
			HEIGHT
			CLEAN FACE				FIREPLACE
			SURROUND				RISER
				KIT
FINISHED	3/8”	3 3/8”	FIREPLACE	HEARTH	3/8”	3 3/8”	FINISHED
FLOOR	CLEARANCE	PLUS	RISER	CLEARANCE		PLUS	FLOOR
		HEARTH	HEARTH			HEARTH
		HEIGHT				HEIGHT

OPTIONAL CLEAN FACE TRIM KIT INSTALLATION

The “wave” clean face surround kit is shown in all illustrations.

NOTE: THE OPTIONAL CLEAN FACE TRIM KIT MUST BE INSTALLED BEFORE PROCEEDING.

1.From the rear side of the clean face surround, insert the weld studs on the top window plate assembly upward through the holes on the underside of the top section of the clean

face surround. (FIGURE 87)

2. Using a socket wrench, secure using the nuts and washers provided. Depending on your surround, space may be tight. (FIGURE 87)

FIGURE 87

3.First secure the clean face surround to the fi replace front by hooking the ledge that runs horizontally on the rear surface of the clean face surround over the bottom edge of the fi replace front opening. (FIGURE 89)

4.With the clean face surround against the fi replace front, hook the surround clips in behind the top lip of the fi replace front opening (FIGURE 89) and secure using the screws provided through the slot in the surround clip and into the pre-drilled hole in the clean face surround. (FIGURE 89) If the optional clean face trim kit was installed, the surround clip fi ts into the cut out and is secured in the same fashion. (FIGURE 90)

FIGURE 89

FIGURE 88

FIGURE 90

FIGURE 91

W415-0661 / C / 02.20.08