32
COMMON FINISHING
BGD36CF / BGD42CF
GLOWING EMBERS
Tear the embers into pieces and place along the front row of ports covering all of the burner area in front of the small logs (#2 & #3). Care should be taken to shred the embers into thin, small irregular pieces as only the exposed edges of the fi bre hairs will glow. The ember material will only glow when exposed to direct flame; however, care should be taken to not block the burner ports.
Blocked burner ports can cause an incorrect fl ame pattern, carbon deposits and delayed ignition. PHAZERTM logs glow when exposed to direct fl ame. Use only certifi ed "glowing embers" and PHAZERTM logs available from your Napoleon® dealer.
CHARCOAL EMBERS
Randomly place the charcoal embers along the front and sides of the log support tray in a realistic manner. Fine dust found in the
bottom of the bag should not be used.
BGD36CFG BULB REPLACEMENT
The BGD36CFG comes equipped with our “Night Light™”. If in the event the lamp or lens needs to be replaced, follow these instructions.
1.Turn off all electrical supply.
2.Remove the glass and glass ember tray from the fi rebox.
3.Unscrew the lens cover making sure the gasket stays in place.
Note: Do not handle the lamp (bulb) with bare fi ngers, protect with FIGURE 110 a clean dry cloth.
4. The lamp will pull straight out of the socket. Replace with 
Gasket Wolf Steel Ltd. parts only
5. Replace lens cover.
6. Replace glass and ember tray.
VERMICULITE
Sprinkle vermiculite around the charcoal embers.
Note: Both charcoal embers and vermiculite are not to be placed on the burner.
CHARCOAL LUMPS (BGD42CF ONLY)
Place the lumps between the logs in a realistic manner taking care not to block any of the burner ports.
LOGO PLACEMENT
½" |
| Remove the backing of the logo | ||
|
|
|
| supplied and place on the glass |
|
|
| LOGO | |
|
|
| viewing door, as indicated. | |
½"
FIGURE 108
BGD36CFG FINISHING
GLASS BURNER INSTALLATION
Spread the clear glass embers
FIGURE 109
Note: The distribution of clear glass embers over the burner tube will infl uence the fl ame height.
BGD36CFG LENS ASSEMBLY REPLACEMENT
1.Remove the glass and glass ember tray.
2.Remove the burner base from the fi rebox.
3.Compress the retainer fins and lift out the lens assembly, disconnect the wires.
4.Replace lens assembly by
aligning key hole and snap into FIGURE 111
place, | KEY HOLE |
5.
6.
!WARNING
The front of the fireplace becomes very hot during operation. Let the fireplace cool completely before conducting service.
NOTE: When removing the glass ember tray make sure the glass embers are away from the center of the screen, exposing the burner, before lifting glass ember tray out.
When replacing burner, absolutely no glass embers can be in cup surrounding the orifi ce. HINT: If glass falls into cup and surrounds the orifi ce, insert a clean bag into a vacuum cleaner and vacuum out glass embers or replacement glass embers can be ordered from Wolf Steel Ltd.