Turbulators
MODEL | 2 Ft. Turbulator Sections |
PTS/U 40 | 4 |
PTS/U 50 | 5 |
PTS/U 75 | 5 |
PTS/U 100 | 3 |
PTS/U 125 | 7 |
PTS/U 150 | 4 |
PTS/U 175 | 0 |
PTS/U 200 | 1 |
ASSEMBLY HAZARD
The PTS / U 40 has one stainless steel turbulator. This must be installed closest to the burner.
Failure to do so may result in deterioration of the turbulator material and invalidate the warranty.
10.3) ADDING REFLECTORS
1.Slide the reflectors on the tube support/hanger brackets and through the wire hangers.
2.The tube at the coupling joints must be covered. Slide the reflectors together and provide an overlap of two (2”) inches for the first reflector overlap after the control unit. All remaining reflector overlaps will be approximately one (1”) inch. This will allow for the natural expansion and contraction of the heater when in operation. Note: The heaters can expand and contract up to
3.Secure the reflectors as shown in Detail “A” using #10 x 1/2”
40 FT SYSTEM SHOWN
The reflector overlap must be able to slide at this joint for expansion of the heater
3” Gap (between burner box and reflector)
1” OVERLAP
|
| 2” OVERLAP |
Burner Box |
|
|
Suspension | REFLECTOR | DETAIL “B” |
Chain |
|
|
BURNER | DETAIL “A” |
|
BOX |
|
|
| DETAIL “B” | REFLECTOR |
REFLECTOR | ||
OVERLAP | OVERLAP | |
(offset from tube | (positioned over tube | |
hanger support brackets) | hanger support brackets) | |
FLUE
TERMINAL
1” OVERLAP
DETAIL “A”
|
| #10 x 1/2” SHEET |
|
| METAL SCREW |
|
| (Typical all tube |
CORRECT INSTALLATION | INCORRECT INSTALLATION | hanger/ |
support brackets.) | ||
Form #43343330 |
|
|
May 08 |
|