Installation (for qualified installers only) | 1 3 |
Electrical Connection
!Make sure the household breaker is shut off prior to working on any electrical lines.
!The appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Code, or ANSI NFPA.
•The electrical line must be 14 gauge, and supply 120 Volts at 60 Hz (2 Amps)
1Follow the directions below to connect power to the fireplace.
a | Remove the cover from the |
fireplace junction box. |
Insert the sheathed cable from the power source through b this cable clamp. Once the wires are attached, tighten
the clamp to secure the cable.
WARNING: Make sure power is off from the power lead before conducting any wiring.
Nutdriver | Standard |
| |
| Screwdriver |
1/4" | d |
| Replace |
| the cover |
| removed |
| in step "a". |
Electrical Connector (shipped in the fireplace behind the cover plate)
Attach the common (white), ground (exposed or green) wires, and hot c (black) wires from the power source to the electrical connector (included
with the fireplace). Then attach the connector to the fireplace.
NOTE:
If using the power heat duct, you may wish to route the wiring for it at this point. See the instructions under "Optional Equipment".
Travis Industries | 4050114 | 1 0 0 - 0 1 1 4 9 |