FireplaceXtrordinair 44 DV XXL EF manual Installation Overview, Recommended Installation Procedure

8 Installation (for qualified installers only)

Installation Overview

See "Power Heat Vent" in the optional equipment section.

3-1/2" Min.

Drywall

See the section "Vent Requirements"

See the section "Horizontal Termination

Requirements"

See the section "Acceptable

Vent Lengths"

Non-combustible facing (see the section "Facing Requirements")

See the section "Mantel Requirements"

See the section "Hearth Requirements"

See the section "Fireplace

Placement Requirements"

Nail

Down

Plate

See the section

"Gas Line Installation"

Insulation must not fill the 1" clearance around the back and sides of the fireplace.

See the section "Electrical Connection"

This grommet and hole is for thermostat wire (on both sides)

See the section "Minimum

Framing Dimensions"

Recommended Installation Procedure

1Frame the opening for the fireplace. Make sure to allow for vent installation and the type of installation (corner or flat wall).

2Insert the fireplace into the framing. Slide it back until the firebox front face is flush with the framing members. Verify all clearances at this point.

3Secure the fireplace to the floor by screwing or nailing through the nail-down plates (found on both sides and back of the fireplace).

4Complete the gas line installation.

5Complete the electrical hook-up.

6Complete the vent installation.

7Install the hearth (if applicable).

8Install the facing.

9Install the mantel (if applicable).

8	4050114	1 0 0 - 0 1 1 4 9
Travis Industries