4 0Operation
Adjusting the Blower Speed
The internal blower helps transfer the heat from the fireplace into the room. It will not turn on until the fireplace is up to temperature (approximately 10 minutes after starting). See the illustration below for instructions on adjusting the blower speed.
OFF | HI |
| |
LO |
|
BLOWER |
|
CONTROL |
|
Blower Knob
Turn the knob all the way
Optional Power Heat Duct
Allow the fireplace to reach normal operating temperature. Then use the
OFF
Turn the dial all the way counter- clockwise until it clicks off.
HIGH
The high position is all the way counter- clockwise, without clicking off.
LOW
Turn the dial all the way clockwise.
Normal Operating Sounds
Pilot Flame
The pilot flame, which remains on, makes a very slight "whisper" sound.
Gas Control Valve
As the gas control valve is turned on and off you will hear a dull clicking sound. This is the valve opening up and shutting down.
Blower
This heater uses two blowers to push heated air into the room. You will hear the sound of air movement that increases as the speed is increased.
The appliance will creak with change of temperature.
Blower Snap Disk
This part can produce a clicking sound as it turns the blower on and off.
Extinction Pops
It is not unusual, especially on Propane (LP) appliances, to experience a "pop" when the burner is shut off.
Normal Operating Odors
This appliance has several areas that reach high temperatures. Dust or other particles on these areas may burn and create an odor. This is normal during
Travis Industries | 4050114 | 1 0 0 - 0 1 1 4 9 |