FireplaceXtrordinair 44 DV XXL EF manual Approved Vent Configurations, Restrictor Position, Elbows

1 6 Installation (for qualified installers only)

Approved Vent Configurations

Restrictor Position

•A vent restrictor is built into the appliance to adjust the flow rate of exhaust gases. This ensures proper combustion for all vent configurations. Depending upon the vent configuration, you may be required to adjust the restrictor position. The charts for acceptable vent configurations detail the correct vent restrictor position.

To Access the Restrictor:

With the face removed and

the fireplace cool, reach

above the firebox.

WARNING: Use a glove to protect your hand from burns.

To Adjust the Restrictor:

1Determine the correct restrictor position (see the charts under

2"Approved Vent Configurations" - the factory position is #1).

Lift up the adjustment plate and move it so the correct notch falls into the slot on the adjustment bracket.

etc. # 2

# 7

Adjustment

Plate

Adjustment
Bracket	To adjust, lift up on the
This restrictor is in position 1	adjustment plate and push it
(factory setting).	back.

Elbows

•See the vent configurations for details on how

many elbows may			Side
be used and in	3-1/2"		View
what manner.
		8"
Measuring Vent		3-1/2"
Lengths
	NOTE:
	Vent sections overlap
	each other by 1-3/4"

	1-3/4"
		Vent
Vent Length		Height
(2', 3', etc.)

This restrictor is in

position 6.

Vent

Horizontal

Run

12-3/8"

Starter

Section

10-3/4" wide with

1-3/4" to

3-3/8" of overlap

43-1/8"

NOTE:

All measurements are for 8" diameter vent.

Travis Industries 4050114 1 0 0 - 0 1 1 4 9