INSTALLATION
BACK-UP BATTERY INSTALLATION
(within Power Module)
The 9V battery operates the rear burner under power outage conditions.
The AA battery operates the DC Sparker for lighting the pilot.
1) Remove the glass door. | 2) Loosen the 2 screws that hold the left side | 4) | Unplug the power source. |
| heat shield in place. | 5) | Loosen the bottom screw and remove the |
a. Release the 2 door latches on the left |
| ||
and right side at the top of the fi rebox. |
|
| top screw from the power module. |
|
|
|
INSTALLATION
Heat
Shield
Latch Location
Latch
3) Lift up and pull out the heat shield slightly to clear the screwheads and then hang it on the top bracket (located directly above the heat shield).
Bracket
b.Swingthedooroutfromthetopandrelease the hinges on the left and right side of the door by lifting them up.
Hinge
Door
Heat
Shield
Power
Module
6)Cut the cable tie that holds together the wires for the power module and the pull out the power module.
7)Remove the power module cover by removing the 2 screws, one on each side.
Power Module
8)Install the 9V battery and the AA battery.
Regency® L676 Direct Vent Gas Fireplace | 27 |