
MAINTENANCE
BACK-UP BATTERY REPLACEMENT
(within Power Module)
1)Remove the exterior brick panels.
2)Remove the glass door.
a.Release the 2 door latches on the left and right side at the top of the fi rebox.
Latch Location
Latch
3)Loosen the 2 screws that hold the left side heat shield in place.
Heat
Shield
7)Pull out the power module.
8)Remove the power module cover by removing the 2 screws, one on each side.
Power Module
9)Replace the 9V battery and the AA battery.
b.Swingthedooroutfromthetopandrelease the hinges on the left and right side of the door by lifting them up.
4)Lift up and pull out the heat shield slightly to clear the screwheads and then hang it on the top bracket (located directly above the heat shield).
Bracket
NOTE: The9Vbatteryoperatestherearburner under power outage conditions. The AA battery operates the DC Sparker for lighting the pilot.
Hinge | Heat |
Door | Shield |
5) Unplug the power source.
6) Loosen the bottom screw and remove the top screw from the power module.
10)Reverse steps to
MAINTENANCE
Power
Module
Regency® L676 Direct Vent Gas Fireplace | 43 |