Regency L676 installation manual Carefully remove the bottom brick panel, Valve, Modulating coil

MAINTENANCE

12) Carefully remove the bottom brick panel.	15)	Disconnect the inlet gas line from the
		valve.
	16)	Disconnect the 2 connectors from the
		modulating coil.

Bottom Brick Panel

13)Loosen the 2 screws that hold the right side heat shield.

17) Disconnect the 2 red wires and 1 black wire from the valve.

Modulating Coil

Heat

Shield

Valve Tray Slightly Removed

19)Disconnect the black and red wires from the solenoid valve.

MAINTENANCE

14)Lift up and pull out the heat shield slightly to clear the head screws and then hang it on the top bracket (located directly above the heat shield).

Bracket

Heat

Shield

Wires

18)Remove the 16 screws that hold the valve tray to the fi rebox and slightly pull out the valve tray.

20)Completely pull out the valve tray.

21)Replace the valve tray and reverse steps to re-install.

22)Turn on the gas supply and check for gas leaks.

23)Plug in the power source.

24)Re-install the left heat shield.

25)Re-install the grate.

26)Re-install the interior brick panels.

27)Re-install the log set.

28)Re-install the glass door.

29)Check the inlet (12" WC) and outlet (10"WC).

30)Re-install the right heat shield.

31)Check operation of fl ame control.

32)Check for proper fl ame appearance.

33)Re-install the exterior brick panels.

Valve Tray

48 Regency® L676 Direct Vent Gas Fireplace