Regency L676 Bracket Heat Shield Front Burner Removed, Hinge Door, Rear Log Stand Grate

INSTALLATION

LP Conversion instructions for when unit is ALREADY INSTALLED.

THIS CONVERSION MUST BE DONE BY A QUALIFIED GAS FITTER, IF IN DOUBT DO NOT DO THIS CONVERSION!!

LP Conversion Kit Contains:

Qty.	Part #	Description
1	910-462	LP Conversion Coil
1	904-573	Cable Tie
1	910-037	LP Pilot Orifice
1	904-345	Orifice #53 (back)
1	904-241	Orifice #56 (front)
1	904-529	Allen Key
1	918-590	LP Conversion Decal
1	908-528	Red Propane Label
1	918-596	Instruction Sheet

c. Place the door on a soft surface to prevent	10) Remove the front burner by removing the
scratching.	screw.
4) Loosen the 2 screws that hold the left side
heat shield in place.

Heat

Shield

Front Burner

INSTALLATION

1)TurncontrolknobtotheOFFpositionand shut off the gas supply to the valve.

2)Remove exterior brick panels, if installed.

3)Remove the glass door.

a.Release the 2 door latches on the left and right side at the top of the firebox.

Latch Location

Latch

5)Lift up and pull out the heat shield slightly to clear the screwheads and then hang it on the top bracket (located directly above the heat shield).

Bracket

Heat

Shield

Front Burner Removed

11)Remove the back burner by removing the screw.

b. Swing the door out from the top and release the hinges on the left and right side of the door by lifting them up.

Hinge

Door

6)Unplug the power source.

7)Remove the log set, if installed.

8)Remove interior brick panels, if installed.

9)Remove the grate by undoing the 2 screws on the right and left side.

Back Burner

12)Remove the rear log stand by removing the 4 screws.

Rear Log Stand

Grate

Regency® L676 Direct Vent Gas Fireplace 31