Regency L676 installation manual J9 Jumper Location

Page 30

INSTALLATION

INSTALLATION

17)Ensure that the new rubber gasket (supplied with coil) is properly positioned and install the new modulating pressure regulator as- sembly to the valve using the screws sup- plied with the kit. Tighten screws securely.

18)Install the enclosed identification label to the valve body where it can be easily seen.

19)Attach the LP conversion decal near or on top of the serial no. decal.

20)Replace yellow "Natural Gas" label with red "Propane" label.

21)Re-install the right side panel and all electrical connections to the valve. (2 grey wires to modulating coil.)

22)Remove the left side panel by undoing the 8 screws.

23)Locate the control box shown below and remove the J9 jumper using needle nose pliers.

J9 Jumper Location

24)Re-install the left side panel.

25)Re-install the rear log support bracket.

26)Adjust the burner aeration settings to the LP settings and install the burners.

Front Burner

5/16"

Rear Burner

1/4"

27)Re-install the grate.

28)Re-install the glass door.

29)Re-install the right heat shield.

30)Continue with completing unit installation.

NOTE: Once the unit has been installed;

a)Turn on the gas supply and check for gas leaks.

b)Check the inlet (12" WC) and outlet (10"WC).

c)Check operation of flame control using the remote control. Refer to FireWizard operation manual for details.

d)Check for proper flame appearance.

Installer Notice:

This instructions must be left with the appliance.

J9 Jumper

30

Regency® L676 Direct Vent Gas Fireplace

Image 30
Contents Libertytm L676 Gas Fireplace Manufactured Mobile Home Requirements Table of Contents Safety Label Copy of Safety DecalRequirements MA Code CO DetectorUnit Dimensions Installation Checklist InstallationGeneral Safety Information Important Message Save These InstructionsManufactured Mobile Home Additional Requirements Heat Release KITHearth Requirements Locating Your GAS FireplaceClearances Mantel Clearances Mantel LEG ClearancesFraming & Finishing Important Header must be metal studUnit Assembly Prior to InstallationFactory set for NG units Venting IntroductionVent Restrictor Position Factory set for LP unitsExterior Vent Termination Requirements Venting Arrangements FPI Kit # Length ContainsInstallation Rigid Pipe Venting Systems8 Rigid Pipe Cross Reference Chart 58DVA-16ABL676 & L900 Direct Vent Fireplace Allowable Horizontal Terminations Horizontal Venting with Two 2 90o Elbows Vertical Venting with Two 2 90o Elbows Vent must be supported at offsets Feet HeightUnit Installation with Horizontal Termination Diagram Unit Installation With Vertical TerminationThis allows for small adjustments Minimum VentUnit Installation Horizontal Termination with Flex Vent SystemGAS Line Power Module BACK-UP Battery InstallationHinge Door Heat Shield Power Module Heat Shield Latch LocationConversion KIT #521-969 from NG to LP Using a flat head screw driver Pilot ShieldHeatClip Heat Shield J9 Jumper Location J9 JumperHinge Door Heat Shield Front BurnerBracket Heat Shield Front Burner Removed Rear Log Stand GrateHeat Shield Modulating Coil WiresBottom Brick Panel Bracket Heat ShieldPilot Shield ClipCable Tie Brick Panel Installation Handle with care. do not Force Into PositionOuterbox of Firebox Bracket Brick Panel Clip Tab Base Brick Panel SlotLOG SET Installation Rear Burner Tube Front Burner TubeBackside of Grate Complete Log Set Installation Aeration Adjustment Wiring DiagramMatching Remote Handset & Control BOX ID Code Lighting ProcedureOperating Instructions Operating InstructionsShutdown Procedure Operation During Power OutageNormal Operating Sounds GAS Appliances Right Side Exterior Brick Panel GAS Control ValveCopy of Lighting Plate Instructions Heat ShieldMaintenance BACK-UP Battery Replacement Bracket Hinge Heat DoorPower Module Replacement Bracket Heat ShieldControl Module Replacement Bracket Hinge HeatControl Module DC Sparker Replacement Battery CoverHeat Shield Replace the DC sparker Valve Tray Replacement Unplug the power sourceCarefully remove the bottom brick panel ValveModulating coil Parts List Main AssemblyDescription Parts List Burner & LOG Assembly Parts List Parts List Parts List Warranty Warranty Limited LifetimeInstaller Please complete the following information