MAINTENANCE
POWER MODULE REPLACEMENT
1)Remove the exterior brick panels.
2)Remove the glass door.
a.Release the 2 door latches on the left and right side at the top of the fi rebox.
Latch Location
Latch
4)Lift up and pull out the heat shield slightly to clear the screwheads and then hang it on the top bracket (located directly above the heat shield).
Bracket
Heat
Shield
8)Remove the 3 connectors from the circuit board.
9)Remove the circuit board from the support bracket by turning it around and pushing the plastic pins with a plier.
MAINTENANCE
b.Swingthedooroutfromthetopandrelease the hinges on the left and right side of the door by lifting them up.
Hinge
Door
3)Loosen the 2 screws that hold the left side heat shield in place.
Heat
Shield
5)Unplug the power source.
6 ) Remove the top screw and loosen the bottom screw that hold the power module in place.
Power
Module
7)Remove the power module cover by removing the 2 screws, one on each side.
Power Module
Power Module with Cover Removed
Circuit Board Removed
10)Replace the circuit board.
11)Reverse steps to
44 | Regency® L676 Direct Vent Gas Fireplace |