Bobbin Winding
•Removing bobbin case
Remove the extension table from the machine by pulling it to the left. Open the shuttle cover(_0 by pulling down the embossed part on the left of the cover.
Raise the needle to its highest position by rotating the handwheel toward you.
(_ Shuttle cover (_ Bobbin case
To remove the bobbin case (_ from the shuttle, pull open the latch of the bobbin case. Pull the bobbin case straight out of the shuttle.
S
i i
•Bobbin winding
[] Release the clutch by pulling out the handwheel. This
wilt stop the needle from moving while you wind the bobbin.
[] Draw thread from spool.
[] Guide the thread around the thread guide.
[]Thread through the hole in the bobbin from the inside to the outside.
[] Put the bobbin on the bobbin winder spindle.
[]
[] []
[]
18