Using and Caring for Your Oven
Display/clock
•When you first plug in the range, a tone will sound and the display will show “88:88.” If, after you set the clock, (see the “Setting the clock” section) the display again shows “88:88,” your electricity was off for a while. Reset the clock.
•The time display will show “Err” and three short tones will sound if a time or tempera- ture is incorrectly entered.
Starting an operation
Changing audible signals
Audible signals tell you if a function is entered correctly or not. They also tell you when a cycle is completed.
To shut off audible signals during programming:
PRESS START and hold
for 4 TIME seconds
START | To shut off all signals except for the | |
| ||
| ||
ENTER |
|
After programming a function, you must press START/ENTER to start the function. If you do not press START/ENTER within 5 seconds of programming, “START?” will show in the display as a reminder.
Canceling an operation
CANCEL
OFF
PRESS STOP and hold
for 4 TIME seconds
To change the
PRESS | SET |
and hold | •MIN |
for 4 | ••HR |
seconds |
|
CANCEL/OFF will cancel any function, except for the Clock Set and Kitchen Timer functions. When you press CANCEL/OFF, the large display will show the time of day.
A short tone will sound to tell you the signals have been changed. Repeat step above to turn the signals back on.
Setting the clock
1. Choose CLOCK SET.
Example:
PRESS CLOCK YOU SEE
SET
HR MIN | MIN SEC |
CLEAN START STOP TIME
2. Set time.
Example: |
|
|
| Example: |
PRESS | 3 | 3 | 0 | YOU SEE |
|
|
HR MIN | MIN SEC |
CLEAN START STOP TIME
3. Start clock.
PRESS START
ENTER
18
If the time has not been entered correctly, three short tones will sound and “Err” is displayed for 1 second. The previous display then reappears. Repeat Steps 1, 2, and 3 to