Frymaster 47 Series operation manual FCC Compliance, Caster/Leg Installation

Page 11

DANGER

This appliance is equipped with a three-prong (grounding) plug for your protection against electrical shock, and must be plugged directly into a properly grounded three-prong receptacle. Do not cut, remove, or otherwise bypass the grounding prong on this plug!

DANGER

This appliance requires electrical power for operation. Place the gas control valve in the OFF position in case of a prolonged power outage. Do not attempt to operate this appliance during a power outage.

FCC COMPLIANCE

The user is cautioned that any changes or modifications to Frymaster computers not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

Frymaster computers have been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. While these devices are verified as Class A devices, they have been shown to meet the Class B limits. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of the equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.

If necessary, the user should consult the dealer or an experienced radio and television technician for additional suggestions.

The user may find the booklet “How to Identify and Resolve Radio-TV Interference Problems” helpful. It is prepared by the Federal Communications Commission and is available from the U.S. Government Printing Office, Washington, DC 20402, Stock No. 004-000-00345-4.

2.2Caster/Leg Installation

Depending upon the specific configuration ordered your fryer may have been shipped without installed casters or legs. If casters or legs are installed, you may skip this section and proceed to section 2.3, Pre-Connection Preparations.

If your fryer requires the installation of casters/legs, install them in accordance with the instructions included in your accessory package.

2-3

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Series Gas Fryers Hour Service HotlineCanada Page Series GAS Fryers Table of Contents Retain and Store this Manual in a Safe Place for Future USE Parts Ordering and Service InformationSeries GAS Fryers General Information Applicability and ValidityEquipment Description Safety InformationEuropean Community CE Specific Information Definitions Installation, Operating, and Service PersonnelWhat to do if your equipment arrives damaged Shipping Damage Claim ProcedureClearance and Ventilation Series GAS Fryers Installation InstructionsGeneral Installation Requirements Electrical Grounding Requirements National Code RequirementsFCC Compliance Caster/Leg InstallationPage CE Standard For Incoming Gas Pressures Non-CE Standard For Incoming Gas PressuresCE Standard CE Standard Burner Manifold Gas Pressures Page Honeywell Gas Valves Converting to Another Gas TypeDual-Vat Non-CE Gas Conversion Kits Robertshaw Gas ValvesCE and Non-CE Gas Conversion Instructions Lighting the Pilot on NON-EUROPEAN NON-CE Fryers Accessing the PilotSeries GAS Fryers Operating Instructions Pilot Button OFF Button Boiling-Out the Frypot Placing the Fryer Into OperationFor units equipped with Thermostat Controls For units equipped with other than Thermostat ControlsPage Controller Operation and Programming Series GAS Fryers Filtration Instructions Page Page Snap the Power Shower into the frypot Page Page Weekly Checks and Services Series GAS Fryers Preventive MaintenanceFryer Preventive Maintenance Checks and Services Daily Checks and ServicesClean Detachable Parts and Accessories Quarterly Checks and ServicesDrain and Clean Frypot Check Computer Magic III Set Point Accuracy Clean Gas Valve Vent TubeCheck Thermostat Controller Thermostat Calibration Fryer SEMI-ANNUAL Checks and ServicesCheck Burner Manifold Pressure Built-In Filtration System Page Introduction Series GAS Fryers Operator TroubleshootingProblem Probable Causes Corrective Action Probable Causes Corrective Action Troubleshooting Fryers with Thermostat ControlsProblem Troubleshooting the Built-In Filtration System Troubleshooting Abnormal Burner OperationVery slow Pump starts, but noTransfer takes place Or the transfer isSpraying properly Power Shower is notReplacing the Controller or Controller Wiring Harness This page Intentionally Left Blank Service Hotline
Top Page Image Contents