Frymaster 47 Series operation manual

Page 29

7.Let the filter run 10 to 12 seconds after oil/shortening stops coming out of the Power Shower to clear the lines and prevent shortening from hardening in them. Rotate the oil return handle to the OFF position to stop the pump. Remove the Power Shower and allow it to drain. Turn the fryer on and allow the cooking oil/shortening to reach setpoint.

DANGER

The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the end of frying operations each day. Some food particles can spontaneously combust if left soaking in certain shortening material.

WARNING

The filter pump is equipped with a manual reset switch in case the filter motor overheats or an electrical fault occurs. If this switch trips, turn off power to the filter system and allow the pump motor to cool 20 minutes before attempting to reset the switch.

The switch is accessed by pulling the filter assembly out of the fryer cabinet so that the motor can be reached. The switch is the red button on the face of the motor (see photo below).

4-6

Image 29

Contents Series Gas Fryers Hour Service HotlineCanada Page Series GAS Fryers Table of Contents Series GAS Fryers General Information Parts Ordering and Service InformationApplicability and Validity Retain and Store this Manual in a Safe Place for Future USEEquipment Description Safety InformationEuropean Community CE Specific Information Definitions Installation, Operating, and Service PersonnelWhat to do if your equipment arrives damaged Shipping Damage Claim ProcedureClearance and Ventilation Series GAS Fryers Installation InstructionsGeneral Installation Requirements Electrical Grounding Requirements National Code RequirementsFCC Compliance Caster/Leg InstallationPage CE Standard For Incoming Gas Pressures Non-CE Standard For Incoming Gas PressuresCE Standard CE Standard Burner Manifold Gas Pressures Page Dual-Vat Converting to Another Gas TypeNon-CE Gas Conversion Kits Robertshaw Gas Valves Honeywell Gas ValvesCE and Non-CE Gas Conversion Instructions Lighting the Pilot on NON-EUROPEAN NON-CE Fryers Accessing the PilotSeries GAS Fryers Operating Instructions Pilot Button OFF Button For units equipped with Thermostat Controls Placing the Fryer Into OperationFor units equipped with other than Thermostat Controls Boiling-Out the FrypotPage Controller Operation and Programming Series GAS Fryers Filtration Instructions Page Page Snap the Power Shower into the frypot Page Page Fryer Preventive Maintenance Checks and Services Series GAS Fryers Preventive MaintenanceDaily Checks and Services Weekly Checks and ServicesClean Detachable Parts and Accessories Quarterly Checks and ServicesDrain and Clean Frypot Check Computer Magic III Set Point Accuracy Clean Gas Valve Vent TubeCheck Thermostat Controller Thermostat Calibration Fryer SEMI-ANNUAL Checks and ServicesCheck Burner Manifold Pressure Built-In Filtration System Page Introduction Series GAS Fryers Operator TroubleshootingProblem Probable Causes Corrective Action Probable Causes Corrective Action Troubleshooting Fryers with Thermostat ControlsProblem Troubleshooting the Built-In Filtration System Troubleshooting Abnormal Burner OperationTransfer takes place Pump starts, but noOr the transfer is Very slowSpraying properly Power Shower is notReplacing the Controller or Controller Wiring Harness This page Intentionally Left Blank Service Hotline