Option Selections Options | Maytag MDB6600WH instruction

OPTION SELECTIONS

OPTIONS

dish load types

DESCRIPTIONS

USE WITH:

ADDED

TIME TO

CYCLE

Tough food soils

Adds heat and wash time to the

Jetclean® Plus Steam, Normal,

30 min.

cycle.

and Auto Clean

Tough food soils

Increases the target water

Jetclean® Plus Steam, Normal,

10 min.

temperature during the wash portions

and Auto Clean

of the cycle. Adds heat, time, and

water.

All loads

Use for best drying results in

Jetclean® Plus Steam, Normal,

45 min.

combination with rinse aid. Turn off

Light, Quick Wash and Auto Clean

when loads contain plastic

dinnerware that may be sensitive to

higher temperatures.

To sanitize your dishes

Raises the water temperature in the

Jetclean® Plus Steam, Normal,

30 min.

and glassware

final rinse to approximately 154°F

and Auto Clean

(68°C). This high temperature rinse

sanitizes your dishes and glassware

in accordance with NSF/ANSI

Standard 184 for Residential

Dishwashers. Certified residential

dishwashers are not intended for

licensed food establishments. The

Sanitize option adds heat and time to

the cycle.

All loads

Delays the start of a cycle up to

All cycles

120, 240,

8 hours.

480 min.

	All loads	When Control Lock is lit, all buttons	All cycles
		are disabled. If you press any pad
		while your dishwasher is locked, the


		light flashes. The door can be opened
		light flashes. The door can be opened
		while the controls are locked.
		while the controls are locked.


CONTROLS AND CYCLE STATUS

CONTROL	PURPOSE	COMMENTS

	To start or resume a	If the door is opened during a cycle or the power is interrupted, the START/RESUME
	wash cycle	indicator flashes. The cycle will not resume until the door is closed and START/RESUME is
	wash cycle
		pressed.
		NOTE: If the START/RESUME button is located on top of door, push door firmly closed
		within 3 seconds of pressing START/RESUME. If the door is not closed within 3 seconds,
		the start button LED will flash, an audible tone will be heard, and the cycle will not start.

	To reset any cycle or	Press CANCEL/DRAIN to reset any control selections made.
	options during


	selection.	See “Canceling A Cycle” and “Changing A Cycle After Dishwasher Is Started” sections.
	To cancel a wash
	To cancel a wash
	cycle after it's
	started.

	To turn the audible	Press and hold the Hi Temp Wash button for 3 seconds to turn the audible tones on or off.
	tones on or off.	Only audible tones for confirming button presses can be turned on/off. Important audible
	tones on or off.
		tones, such as indicating a cycle has been interrupted, cannot be deactivated.
		NOTE: Audible tones are not available on all models.