Miele 06 868 521, G 7856 installation instructions Salt indicator, Water softener

Page 15
Salt indicator

Water softener

Salt indicator

When the salt reservoir is empty the "Recharge" indicator, b, lights as a reminder to fill the reservoir.

Reactivation takes place automatically during a program. The "Recharging" indicator, a, lights while this is occurring.

15

Image 15
Contents Operating and Installation Instructions Commercial Dishwasher Gen - US Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine Accessories Disposal of the old machineSAVE THESE INSTRUCTIONS c Salt reservoir water softener Guide to the machinelocated on the rear side of the machine b Filter combinationa On/Off button I-0 b Door button cDisplay Description of the machine Opening and closing the door To open the doorTo close the door Setting the water softener Water softenerWater Softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machineItems not suitable for dishwashers Please noteOur recommendations Loading examples Upper basketBottom basket CutleryTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Maintenance of the dispensing systems Rapid programEvery 12-18months Starting a program Turning onTurning off Selecting an additional functionProgram sequence display At the end of a programChanging a program Canceling a programProgram cycle Program guideWhen to use ProgramNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinse6.Delay start and setting the delay start time b Setting the delay start perioda To activate Delay Start 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump To clean the filters Cleaning the filters in the water inletCleaning the control panel Cleaning the front of the machineFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Caring for the environment Disposal of the packing materialDisposal of the appliance Installation Installation options -Free-standing -UndercounterOpen the door Cover plate protects the countertop Leveling the machinePosition and secure the machine Stainless steel toe kickElectrical connection THIS APPLIANCE MUST BE GROUNDEDPLEASE NOTE Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage Technical data EnglishMetric Page Page M.-Nr.06 All rights reserved