Miele 06 868 521, G 7856 Programming special functions, Temperature holding time Final rinse

Page 33

Programming special functions

^Temperature "Final rinse": Turn the program selector to the "STOP" position (the programming level is displayed in this position only).

^Press "Extra Drying" again. "E05" (programming level 5) is displayed field.

^Turn the program selector to the program to be changed. The actual value is displayed after °F.

^Press and hold "Display", until the desired value is displayed.

^Temperature holding time "Final rinse":

Turn the program selector to the "STOP" position (the programming level is displayed in this position only).

^Press "Extra Drying" again. "E06" (programming level 6) is displayed field.

^Turn the program selector to the program to be changed. The actual value is displayed after min.

^Press "Display" until the required value is displayed.

^Having changed a value or all values:

^Press the "Start" button. "SP" is displayed.

^Press the "Start" button again. The change has been saved.

33

Image 33

Contents Operating and Installation Instructions Commercial Dishwasher Gen - US Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine Accessories Disposal of the old machineSAVE THESE INSTRUCTIONS located on the rear side of the machine Guide to the machineb Filter combination c Salt reservoir water softenera On/Off button I-0 b Door button cDisplay Description of the machine Opening and closing the door To open the doorTo close the door Setting the water softener Water softenerWater Softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machineItems not suitable for dishwashers Please noteOur recommendations Bottom basket Upper basketCutlery Loading examplesTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Maintenance of the dispensing systems Rapid programEvery 12-18months Starting a program Turning onProgram sequence display Selecting an additional functionAt the end of a program Turning offChanging a program Canceling a programWhen to use Program guideProgram Program cycleNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinse6.Delay start and setting the delay start time b Setting the delay start perioda To activate Delay Start 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump Cleaning the control panel Cleaning the filters in the water inletCleaning the front of the machine To clean the filtersFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Caring for the environment Disposal of the packing materialDisposal of the appliance Installation Installation options -Free-standing -UndercounterOpen the door Position and secure the machine Leveling the machineStainless steel toe kick Cover plate protects the countertopElectrical connection THIS APPLIANCE MUST BE GROUNDEDPLEASE NOTE Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage Technical data EnglishMetric Page Page M.-Nr.06 All rights reserved