Programming special functions
Every change of the factory setting should be documented in case of possible technical service. Record any changes in the field "Adjusted value___________".
1.Setting the cold water inlet from: "Nominal water intake" to "Nominal water intake + 1 l".
The amount of water taken into the machine at each intake can be increased by 1 liter to a maximum of 9.5 liters.
^Turn the program selector to "STOP".
^Turn the machine off.
^Press and hold the "Display" and "Start" buttons, at the same time turn the machine on with the "On / Off button". The displays shows the current program status "P...".
The "Fill/Drain" indicator lights.
^Press the "Extra Drying" button once. "E01" (programming level 1) is displayed.
^Turn the program selector to "China & Crystal".
Either "10" or "11" is displayed. "10" = Nominal water intake
"11" = Nominal water intake + 1 liter
^Press "Display" to change from "10" to "11" or vice versa.
^Press the "Start" button. "SP" is displayed.
^Press the "Start" button again. The change has been saved.
Value set:
2. Selecting a second interim rinse
A second interim rinse "Interim rinse II" can be programmed to improve interim rinsing in all programs (except for "Rinse" and "Rapid").
^Turn the program selector to "STOP".
^Turn the machine off.
^Press and hold the "Display" and "Start" buttons, at the same time turn the machine on with the "On / Off" button.
The display shows the current program status "P...".
The "Fill/Drain" indicator lights.
^Press the "Extra Drying" button once. "E01" (programming level 1) is displayed.
^Turn the program selector to "Rapid". "30" or "31" is displayed.
"30" = without interim rinse II "31" = with interim rinse II.
^Press "Display" to change from "30" to "31" or vice versa.
^Press the "Start" button. "SP" is displayed.
^Press the "Start" button again. The change has been saved.
Value set:
29