Miele 06 868 521, G 7856 Disposal of the old machine, Accessories, Important Safety Instructions

Page 7
Disposal of the old machine

IMPORTANT SAFETY INSTRUCTIONS

~In critical applications where very stringent requirements must be met, it is highly recommended that all relevant factors for the process, such as cleaning agent, quality of water, etc., be discussed with a Miele Application Specialist.

~The special inserts should only be used for their specific application.

~Do not wash plastic items unless they are marked "dishwasher safe" or the equivalent. If in doubt follow the manufacturers recommendations.

~Empty any containers or utensils before arranging them in the machine.

~Do not allow any remains of acids or solvents, particularly hydrochloric acid or chloride solutions, to get into the wash cabinet. The presence of any solvents should be minimized (especially those in hazard class A1).

~To avoid corrosion damage ensure that solutions or steam containing hydrochloric acid do not come into contact with the steel outer casing of the machine.

Disposal of the old machine

~When disposing of your old dishwasher first make it unusable. Disconnect it from the mains power supply, cut off the cable and plug from the cable.

~For environmental and safety reasons ensure the machine is completely drained of any residual water and detergent. (Observe safety regulations and wear safety goggles and gloves).

~Remove the door to the washing compartment, so that children cannot accidentally shut themselves in. Make appropriate arrangements for the safe and environmentally responsible disposal of the machine.

~For tank system machines ensure that all water is emptied out the tank.

The manufacturer cannot be held responsible for any damage caused by non-observance of these Important Safety Instructions.

Accessories

~Only specific additional equipment, made by Miele or approved by Miele, should be connected to this machine. Consult Miele on the type and application of such equipment.

SAVE THESE INSTRUCTIONS

7

Image 7
Contents Commercial Dishwasher G Operating and Installation Instructionsen - US Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine Disposal of the old machine AccessoriesSAVE THESE INSTRUCTIONS c Salt reservoir water softener Guide to the machinelocated on the rear side of the machine b Filter combinationa On/Off button I-0 b Door button cDisplay Description of the machine To open the door Opening and closing the doorTo close the door Water softener Setting the water softenerWater Softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machinePlease note Items not suitable for dishwashersOur recommendations Loading examples Upper basketBottom basket CutleryTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Rapid program Maintenance of the dispensing systemsEvery 12-18months Starting a program Turning onTurning off Selecting an additional functionProgram sequence display At the end of a programChanging a program Canceling a programProgram cycle Program guideWhen to use ProgramNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinseb Setting the delay start period 6.Delay start and setting the delay start timea To activate Delay Start 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump To clean the filters Cleaning the filters in the water inletCleaning the control panel Cleaning the front of the machineFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Disposal of the packing material Caring for the environmentDisposal of the appliance Installation options -Free-standing -Undercounter InstallationOpen the door Cover plate protects the countertop Leveling the machinePosition and secure the machine Stainless steel toe kickTHIS APPLIANCE MUST BE GROUNDED Electrical connectionPLEASE NOTE Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage English Technical dataMetric Page Page M.-Nr.06 All rights reserved