Miele 06 868 521, G 7856 Selecting an additional function, Program sequence display, Turning off

Page 25
Selecting an additional function

Use

Selecting an additional function

"Extra drying" can be selected as an additional function.

^Select the drying function directly after a program has been selected (not with "Rapid", "Rinse" and "Drain").

Drying is phased over 10 minutes. The total running time of the program lengthens accordingly.

Program sequence display

The indicator for the active program sequence lights up during the program.

Recharging

Pre-wash

Wash

Rinse

Dry (optional function)

At the end of a program

At the end of a program the program sequence indicators and the "Start" indicator go out. The display shows "0" and a buzzer sounds for 30 seconds (factory setting). The buzzer can be changed (see "Programming special functions").

^If desired use the "Display" button to see the total running time of a program or the actual temperature.

To turn the buzzer off

^Turn the program selector to "STOP".

or

^Open the door.

Turning off

^Press and release the "On / Off" button.

25

Image 25
Contents Commercial Dishwasher G Operating and Installation Instructionsen - US Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine Disposal of the old machine AccessoriesSAVE THESE INSTRUCTIONS located on the rear side of the machine Guide to the machineb Filter combination c Salt reservoir water softenera On/Off button I-0 b Door button cDisplay Description of the machine To open the door Opening and closing the doorTo close the door Water softener Setting the water softenerWater Softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machinePlease note Items not suitable for dishwashersOur recommendations Bottom basket Upper basketCutlery Loading examplesTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Rapid program Maintenance of the dispensing systemsEvery 12-18months Starting a program Turning onProgram sequence display Selecting an additional functionAt the end of a program Turning offChanging a program Canceling a programWhen to use Program guideProgram Program cycleNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinseb Setting the delay start period 6.Delay start and setting the delay start timea To activate Delay Start 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump Cleaning the control panel Cleaning the filters in the water inletCleaning the front of the machine To clean the filtersFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Disposal of the packing material Caring for the environmentDisposal of the appliance Installation options -Free-standing -Undercounter InstallationOpen the door Position and secure the machine Leveling the machineStainless steel toe kick Cover plate protects the countertopTHIS APPLIANCE MUST BE GROUNDED Electrical connectionPLEASE NOTE Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage English Technical dataMetric Page Page M.-Nr.06 All rights reserved