Miele G 7856, 06 868 521 Programming special functions, Turn the program selector to STOP

Page 36

Programming special functions

8.Re-setting all changes back to the factory default

^Turn the program selector to "STOP".

^Turn the machine off.

^Press and hold the "Display" and "Start" buttons, at the same time turn the machine on with the"On / Off" button.

The display shows the current program status "P...".

The "Fill/Drain" indicator lights.

^Press "Extra Drying" seven times. "E07" (programming level 7) is displayed.

^Turn the program selector to any position (except "STOP").

The display shows either "00" or "PP". "00" = factory setting

(electronic was not reset). "PP" = Electronic was reset.

^If "PP" is displayed press "Display" to change from "PP" to "00".

^Press the "Start" button. "SP" is displayed.

^Press the "Start" button again. Values which had been changed are now reset.

If the hardness level setting in the water softener had been changed this will reset to the factory setting of 19 gr/gal (19 °d). This will need to be adjusted back to the hardness level in your area.

Image 36

Contents Operating and Installation Instructions Commercial Dishwasher Gen - US Page Contents IMPORTANT SAFETY INSTRUCTIONS Installation and serviceIMPORTANT SAFETY INSTRUCTIONS components of the machine Accessories Disposal of the old machineSAVE THESE INSTRUCTIONS Guide to the machine located on the rear side of the machineb Filter combination c Salt reservoir water softenera On/Off button I-0 b Door button cDisplay Description of the machine Opening and closing the door To open the doorTo close the door Setting the water softener Water softenerWater Softener Table of settings factory settingFilling the salt reservoir Salt indicator Rinse aid Adding rinse aidSetting the dosage Loading the machine Loading the machineItems not suitable for dishwashers Please noteOur recommendations Upper basket Bottom basketCutlery Loading examplesAdjusting the upper basket To adjust the upper basketAdding cleaning agent Maintenance of the dispensing systems Rapid programEvery 12-18months Turning on Starting a programSelecting an additional function Program sequence displayAt the end of a program Turning offCanceling a program Changing a programProgram guide When to useProgram Program cycleNORMAL Programming special functions 2. Selecting a second interim rinseVenting the dispensing system Setting the dosage Having changed a value or all valuesTemperature holding time Main wash Temperature holding time Final rinse Having changed a value or all values6.Delay start and setting the delay start time b Setting the delay start perioda To activate Delay Start 7. Buzzer Programming special functions Machine care Filter combinationCleaning the spray arms Cleaning the non-returnvalve and drain pump Cleaning the filters in the water inlet Cleaning the control panelCleaning the front of the machine To clean the filtersCorrecting minor faults Faults / possible causesRemove the cause of the fault After Sales Service Page Installation Instructions Caring for the environment Disposal of the packing materialDisposal of the appliance Installation Installation options -Free-standing -UndercounterOpen the door Leveling the machine Position and secure the machineStainless steel toe kick Cover plate protects the countertopElectrical connection THIS APPLIANCE MUST BE GROUNDEDPLEASE NOTE Isolate the machine from the power supply Plumbing Connection to the water inletDrainage Technical data EnglishMetric Page Page All rights reserved M.-Nr.06