Miele 06 868 521, G 7856 installation instructions Machine care, Filter combination

Page 37
Machine care

Machine care

Filter combination

,The machine must not be used without all filters in place. The filters protect the circulation pump from damage caused by foreign objects.

The filter combination in the base of the wash cabinet should be inspected regularly and cleaned if necessary.

Caution:

Watch out for sharp objects which could cause injury.

Cleaning the coarse filter

^Press the two tabs together. Remove and clean the coarse filter.

^Put the clean filter back in position and press until it clicks in place.

Cleaning the fine, flat and micro-fine filters

^Remove the coarse filter.

^Remove the fine filter (if fitted) from bet- ween the flat and micro-fine filters.

^To unscrew the micro-fine filter, grasp the two tabs and turn counter-clockwise twice.

^Remove both filters together.

^Clean the filters.

^Replace the filter combination in the reverse order. The flat filter must lie flat in the base of the wash cabinet.

37

Image 37
Contents Commercial Dishwasher G Operating and Installation Instructionsen - US Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine Disposal of the old machine AccessoriesSAVE THESE INSTRUCTIONS located on the rear side of the machine Guide to the machineb Filter combination c Salt reservoir water softenera On/Off button I-0 b Door button cDisplay Description of the machine To open the door Opening and closing the doorTo close the door Water softener Setting the water softenerWater Softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machinePlease note Items not suitable for dishwashersOur recommendations Bottom basket Upper basketCutlery Loading examplesTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Rapid program Maintenance of the dispensing systemsEvery 12-18months Starting a program Turning onProgram sequence display Selecting an additional functionAt the end of a program Turning offChanging a program Canceling a programWhen to use Program guideProgram Program cycleNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinseb Setting the delay start period 6.Delay start and setting the delay start timea To activate Delay Start 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump Cleaning the control panel Cleaning the filters in the water inletCleaning the front of the machine To clean the filtersFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Disposal of the packing material Caring for the environmentDisposal of the appliance Installation options -Free-standing -Undercounter InstallationOpen the door Position and secure the machine Leveling the machineStainless steel toe kick Cover plate protects the countertopTHIS APPLIANCE MUST BE GROUNDED Electrical connectionPLEASE NOTE Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage English Technical dataMetric Page Page M.-Nr.06 All rights reserved