Miele 06 868 521 Maintenance of the dispensing systems, Adding cleaning agent, Rapid program

Page 23

"Rapid" program

Adding cleaning agent

"Rapid" program

^If liquid cleaning agent is not being used, add powder detergent directly to the inside of the door for this program.

A different combination of cleaning agents and other additives may be necessary for special soiling. Contact Miele fore more information.

Note

This machine can be equipped with a dispenser pump for liquid cleaning agent (DOS-Module G 60) as an optional accessory. This is connected externally.

To vent the dosage system and set the dosage concentration see, "Programming special functions".

The DOS module comes with a separate Installation Manual.

Maintenance of the dispensing systems

The following maintenance should be carried out by a Miele Service Technician to ensure trouble-free operation.

Every 12-18 months:

^Replace the dispensing hoses in the DOS module.

,CAUTION when handling liquid agents and additives! They may contain irritant or caustic ingredients.

Please follow the manufacturer's safety instructions.

Wear protective gloves and goggles.

23

Image 23

Contents en - US Operating and Installation InstructionsCommercial Dishwasher G Page Contents Installation and service IMPORTANT SAFETY INSTRUCTIONSIMPORTANT SAFETY INSTRUCTIONS components of the machine SAVE THESE INSTRUCTIONS AccessoriesDisposal of the old machine c Salt reservoir water softener Guide to the machinelocated on the rear side of the machine b Filter combinationa On/Off button I-0 b Door button cDisplay Description of the machine To close the door Opening and closing the doorTo open the door Water Softener Setting the water softenerWater softener factory setting Table of settingsFilling the salt reservoir Salt indicator Adding rinse aid Rinse aidSetting the dosage Loading the machine Loading the machineOur recommendations Items not suitable for dishwashersPlease note Loading examples Upper basketBottom basket CutleryTo adjust the upper basket Adjusting the upper basketAdding cleaning agent Every 12-18months Maintenance of the dispensing systemsRapid program Starting a program Turning onTurning off Selecting an additional functionProgram sequence display At the end of a programChanging a program Canceling a programProgram cycle Program guideWhen to use ProgramNORMAL 2. Selecting a second interim rinse Programming special functionsVenting the dispensing system Having changed a value or all values Setting the dosageTemperature holding time Main wash Having changed a value or all values Temperature holding time Final rinsea To activate Delay Start 6.Delay start and setting the delay start timeb Setting the delay start period 7. Buzzer Turn the program selector to STOP Filter combination Machine careCleaning the spray arms Cleaning the non-returnvalve and drain pump To clean the filters Cleaning the filters in the water inletCleaning the control panel Cleaning the front of the machineFaults / possible causes Correcting minor faultsRemove the cause of the fault After Sales Service Page Installation Instructions Disposal of the appliance Caring for the environmentDisposal of the packing material Open the door InstallationInstallation options -Free-standing -Undercounter Cover plate protects the countertop Leveling the machinePosition and secure the machine Stainless steel toe kickPLEASE NOTE Electrical connectionTHIS APPLIANCE MUST BE GROUNDED Isolate the machine from the power supply Connection to the water inlet PlumbingDrainage Metric Technical dataEnglish Page Page M.-Nr.06 All rights reserved