Thermador PD30 installation instructions GAS and Electric Supply Zones, Npt

Step 2: Cabinet Preparation

GAS AND ELECTRIC SUPPLY ZONES:

FIG. 3A Gas & Electrical Supply Zone for Dual Fuel Ranges

Typical place- ment shown. Other placement of Gas Supply and Electrical R e c e p t a c l e within the Elec- trical and Gas Supply Zone is acceptable.

NOTE:

If not already present, install gas shut-off valve in an eas- ily accessible location. Make sure all users know where and how to shut off the gas supply to the range.

NOTE: The in- staller should inform the con- sumer of the lo- cation of the gas shut-off valve.

3/4" Flex Line to Appliance

Gas				1/2"
Supply					240 VAC Receptacle
				NPT
Zone
					(Shown) or Junction
➤					Box	Centerline of
	A	➤
						Electrical
			➤
						Supply Zone
				B			➤		➤
2" Maximum Protru-
sion from Wall for							E		D
Gas Supply
						➤	➤		➤
					Floor		➤
								C
									➤

Model	A	B	C	D	E
30"	8"	12"	10"	6-1/2"	5-1/4"
36"	10-1/2"	15"	10-1/2"	6-1/2"	5-1/4"
48"	16-1/2"	16"	15-1/2"	6-1/2"	5-1/4"

NOTE: Any opening in the wall behind the appliance and any opening in the floor under the appliance must be sealed.

The Dual Fuel ranges may be connected to the power supply with a range supply cord kit or by hard-wiring to the power supply. It is the responsibility of the in- staller to provide the proper wir- ing components (cord or conduit and wires) and complete the elec- trical connection as dictated by local codes and ordinances, and/ or the National Electric Code. The units must be properly grounded. Refer to Step 6 for details.

The range must be connected only to the type of gas for which it is certified. If the range is to be connected to propane gas, en- sure that the propane gas supply tank is equipped with its own high pressure regulator in addition to the pressure regulator supplied with the range. (See Step 5.)

6