www.GEAppliances.com
Safety
Preparing for Vacation
For long vacations or absences, remove food and unplug the refrigerator. Move the refrigerator control to the 0 (off) position and clean the interior with a baking soda solution of one tablespoon (15 ml) of baking soda to one quart (1 liter) of water. Leave the doors open.
Set the icemaker power switch to the O (off) position or move the feeler arm to the STOP (up) position (depending on model) and shut off the water supply to the refrigerator.
If the temperature can drop below freezing, have a qualified servicer drain the water supply system (on some models) to prevent serious property damage due to flooding.
Instructions Operating
Preparing to Move
Secure all loose items such as grille, | Be sure the refrigerator stays in an upright position |
shelves and drawers by taping them | during moving. |
securely in place to prevent damage. |
|
Replacing the light bulbs.
Setting either or both controls to 0 (off) does not remove power to the light circuit.
Instructions Installation
Refrigerator Compartment—Upper Light
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
The bulbs are located at the top of the
Some models have only one light.
compartment near the opening.
Replace with an appliance bulb of the same or lower wattage.
Plug the refrigerator back in.
Instructions
Freezer Compartment Dome Light (on some models)
CAUTION: Light bulbs may be hot.
Unplug the refrigerator.
Light shield
The bulb is located behind a light shield at the back of the freezer compartment. To remove, squeeze the top and bottom of the shield and pull the shield off.
After replacing with an appliance bulb of the same or lower wattage, replace the shield.
Plug the refrigerator back in.
Troubleshooting Tips Consumer Support
13