Installation Instructions
4TRANSFER BOTTOM HINGE
BRACKET TO THE LEFT
For models with a base grille, remove it by grasping it about 6″ from each end and pulling its bottom edge toward you.
Using a Torx® driver, move the bottom hinge bracket and plastic washer from the right side to the left side.
NOTE: If the washer is not on the hinge bracket, check to see if it is stuck to the bottom of the door.
Plastic Washer
Hinge Bracket
For models with a base grille, before replacing the base grille, remove the grille cap by removing the screw. Screw the cap to the opposite side.
Replace the base grille by inserting the tops of the metal clips into the oval vents, making sure one of the plastic tabs on the back of the grille goes into each of the oven vents. Then push the bottom of the grille forward until it snaps into place.
5TRANSFER CENTER HINGE
BRACKET TO THE LEFT
Remove the center hinge bracket by removing the three Torx® screws.
NOTE: Keep these screws with the hinge bracket. They are long screws and will be used when installing the hinge on the other side.
On some models, you will need to remove the color- matched caps from the screw heads before you can remove the screws. Use the edge of a thin flat blade to gently pry the caps off the screw heads. (A putty knife works well for this.) Cover the blade with tape to prevent scratching the paint.
Remove the three Torx® screws from the center left side of the cabinet. Screw them into the holes on the right side.
Place the center hinge bracket over the holes at the center left side of the cabinet. Insert and tighten the three long screws.
Replace the caps by snapping them over the screws with your finger.
Screw Cap
6TRANSFER DOOR STOPS
On each door, move the metal door stop from the right to the left.
Move any screws from the left to the right.
Door Stop | Door Stop |
Left Side | Right Side |
21