10OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
QUICK START
1.LOAD THE DISHES
Scrape the dishes free of excess food, bones, and any other hard,
2.MEASURE THE DETERGENT
Using the guidelines in this manual, fill the detergent cup with the recommended amount of detergent and close the lid. If a prewash is desired, the recess on top of the lid should also be filled with detergent.
3.TURN ON THE DISHWASHER
To turn on the display panel, press the Power button.
4.CHECK THE RINSE AID
The Rinse Aid indicator light will illuminate if the level of rinse aid in the dishwasher is low. Add rinse aid if the level is low to maintain the effectiveness of the dry cycle.
5.SELECT THE CYCLE AND OPTIONS
Select the cycle and options that best fit the load by referring to the Cycle Selection Chart. The display will show the esti- mated time for the cycle and options selected.
6.CLOSE THE DOOR
CAUTION
Empty the lower rack first and then the upper rack. This will avoid water from dripping from the upper rack onto dishes in the lower rack.
WARNING
In general, it is not advisable to open the door while the dish- washer is in operation. If the door is opened, a safety device stops the dishwasher. Care should be taken when opening the door im- mediately following the cycle, as steam may escape.
AUTO-OFF
The dishwasher will automatically turn off if a cycle is not selected or if the door is not closed within four minutes.
The dishwasher will start automatically, after a slight delay, when the door is closed and latched. During the cycle, the display will indicate the estimated time remaining for the cycle and options selected. If the door is opened during the cycle, the dishwasher will stop. When the door is closed, the cycle will resume from the point where it was stopped.
7.END OF CYCLE
When the cycle is complete, a chime will sound and the dis- play will show “END.” After a short time, the display and con- trols will shut off for safety and energy conservation.