10. Insert the | Lower Rear Corner |
locking nuts for each caster. |
|
A
B
C
D
A.Self-locking nut
B.Caster bracket
C.⁵⁄₁₆–18 x ⁷⁄₈" hex-head bolt
D.Caster
11.Hold the head of the
12.Using a ¹⁄₂" socket wrench, remove the 4 unit bolts (2 on each side) from the lower front and rear of the convertible refrigerator/ freezer.
NOTE: Do not remove leveling bolt.
Lower Front Corner
A
B
A. Leveling bolt (do not remove)
B. Unit bolt
13.Place the slot in the rear of the caster bracket over the hole in the rear of the convertible refrigerator/freezer. Align the hole in the front of the caster bracket with the hole in the front of the convertible refrigerator/freezer.
A
B
A. Rear convertible refrigerator/freezer hole
B. Caster Bracket
14.Hold the bracket in place and insert the unit bolts into the front and rear unit holes and tighten.
NOTE: Do not overtighten the bolts.
15.Insert 2 of the
A
A. Caster bracket holes
16.Repeat steps 12 – 14 for the second caster bracket.
Complete the Assembly
1.Lock the front caster wheels.
2.Insert a small piece of cardboard between the caster brake and the floor. This will help prevent the brake from rubbing on the floor.
3.Stand the convertible refrigerator/freezer upright.
4.Replace the base grille by placing the metal clips in the openings in the metal panel and rolling the grille downward until it snaps into place.
5.Unlock the wheels and move the convertible refrigerator/freezer into its desired location.
6.After the convertible refrigerator/freezer is in position, relock the wheels.
7.Plug in convertible refrigerator/freezer or reconnect power.
8