Whirlpool W10266784A Ice Maker and Storage Bin, Water Filtration System, on some models, Style

Page 11
Ice Maker and Storage Bin

Ice Maker and Storage Bin

(on some models)

Turning the Ice Maker On/Off

Style 1

nTo turn ON the ice maker, simply lower the wire shutoff arm.

nTo manually turn off the ice maker, lift the wire shutoff arm to the OFF (arm up) position and listen for the click. Ice can still be dispensed, but no more can be made.

NOTE: Your ice maker has an automatic shutoff. As ice is made, the ice cubes will fill the ice storage bin, and the ice cubes will raise the wire shutoff arm to the OFF (arm up) position. Do not force the wire shutoff arm up or down.

Style 2

The On/Off switch is located on the top right-hand side of the freezer compartment.

nTo turn on the ice maker, slide the control to the ON (left) position.

nTo manually turn off the ice maker, slide the control to the OFF (right) position.

NOTE: Your ice maker has an automatic shutoff. The ice maker sensors will automatically stop ice production, but the control will remain in the ON (left) position.

REMEMBER:

nAllow 24 hours to produce the first batch of ice. Discard the first three batches of ice produced.

nThe quality of your ice will be only as good as the quality of the water supplied to your ice maker. Avoid connecting the ice maker to a softened water supply. Water softener chemicals (such as salt) can damage parts of the ice maker and lead to poor quality ice. If a softened water supply cannot be avoided, make sure the water softener is operating properly and is well maintained.

nDo not use anything sharp to break up the ice in the storage bin. This can cause damage to the ice container and the dispenser mechanism.

nDo not store anything on top of or in the ice maker or storage bin.

Removing and Replacing Ice Storage Bin

Style 1

1.Pull the covering panel up from the bottom and then slide it back toward the rear.

2.Lift the wire shutoff arm so it clicks into the OFF (up) position.

3.Lift up the front of the storage bin and pull it out.

4.Replace the bin by pushing it in all the way or the dispenser will not work.

5.To restart ice production, push the wire shutoff arm down to the ON position. Make sure the door is closed tightly.

Style 2

1.Hold the base of the storage bin with both hands and press the release button to lift the storage bin up and out.

NOTE: It is not necessary to turn the ice maker control to the OFF (right) position when removing the storage bin. The sensor cover (“flipper door”) on the left wall of the freezer stops the ice maker from producing ice if the door is open or the storage bin is removed.

2.Replace the storage bin on the door and push down to make sure it is securely in place.

Water Filtration System

Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system. Systems certified for cyst reduction may be used on disinfected waters that may contain filterable cysts.

Water Filter Status Light (on some models)

The water filter status light will help you know when to change your water filter. When the water filter status display changes from “GOOD” to “ORDER,” this tells you that it is almost time to change the water filter cartridge. Replace the water filter cartridge when the water filter status display changes to “REPLACE.” If water flow to your water dispenser or ice maker decreases noticeably, change the filter sooner. The filter should be replaced at least every 6 months depending on your water quality and usage.

After changing the water filter, reset the status light by pressing and holding the FILTER button for 3 seconds. The status light will change from “REPLACE” to “NEW” or “GOOD” when the system is reset.

Changing the Water Filter

1.Press the eject button to release the filter from the base grille.

2.Pull the filter straight out.

3.Turn the cap counterclockwise to remove it from the filter.

IMPORTANT: Do not discard the cap. It is part of your refrigerator. Keep the cap to use with the replacement filter.

4.Align the ridge on the cap with the arrow on the new filter and turn the cap until it snaps into place.

NOTE: You can run the dispenser without a filter. Your water will not be filtered. Simply insert the cap all of the way into the base grille and rotate the cap until it is firmly in place.

5.Remove the covers from the O-rings. Be sure the O-rings are still in place after the covers are removed.

6.Push the filter into the base grille. The eject button will pop back out when the filter is fully engaged.

7.Flush the water system. See “Water and Ice Dispensers.”

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents W10266784A DANGER TABLE OF CONTENTSREFRIGERATOR SAFETY IMPORTANT SAFETY INSTRUCTIONSUse two or more people to move and install refrigerator INSTALLATION INSTRUCTIONSClean Before Using Excessive Weight HazardElectrical Shock Hazard Plug into a grounded earthed outlet Electrical Shock Hazard Disconnect power before servicingElectrical Requirements Recommended Grounding MethodWiring Connection Electrical Shock Hazard Disconnect power before removing doorsRefrigerator Doors A B CReplace the Doors and Hinges Models with Water and Ice Dispensers Remove the DoorsModels with Water and Ice Dispensers Models without Water and Ice DispensersWater Pressure Adjust the DoorsWater Supply Requirements Connect Water SupplyElectrical Shock Hazard Plug into a grounded 3 prong outlet Complete the InstallationConnect to Refrigerator Style E F GConvertible Drawer Temperature Control Using the ControlsAdjusting Controls REFRIGERATOR USETo Dispense Water Cut Hazard Use a sturdy glass when dispensing iceWater and Ice Dispensers The Water DispenserRemoving and Replacing Ice Storage Bin Style Ice Maker and Storage BinWater Filtration System Turning the Ice Maker On/Off StyleREFRIGERATOR CARE CleaningTo Clean Your Refrigerator Explosion Hazard Use nonflammable cleanerThe doors will not close completely TROUBLESHOOTINGRefrigerator Operation The refrigerator will not operateThere is interior moisture buildup Temperature and MoistureIce and Water Temperature is too warmReplacement Filters ACCESSORIESASSISTANCE OR SERVICE Stainless Steel Cleaner and PolishSu seguridad y la seguridad de los demás es muy importante ÍNDICESEGURIDAD DEL FRIGORÍFICO PELIGRO ADVERTENCIADesembale el frigorífico INSTRUCCIONES DE INSTALACIÓNADVERTENCIA Cómo deshacerse adecuadamente de su frigorífico viejoPeligro de descarga eléctrica Requisitos eléctricosMétodo de conexión a tierra recomendado No use un adaptador No use un cable eléctrico de extensiónizquierda Puertas del frigoríficoDesconecte el suministro de energía antes de sacar las puertas Bisagra superiorModelos sin dispensadores de agua y hielo Modelos con dispensadores de agua y hieloSuministro de agua por ósmosis inversa Ajuste las puertasRequisitos del suministro de agua Conexión del suministro de aguaA B C D E F E DNo quite el terminal de conexión a tierra No use un adaptador USO DE SU FRIGORÍFICOUso de los controles Conecte a un enchufe de conexión a tierra de 3 terminalesDispensadores de agua y hielo Control de temperatura del cajón convertibleControl de humedad del cajón para verduras Depósito enfriador de la puertaPeligro de cortes Fábrica de hielo y depósitoPara dispensar agua Para dispensar hieloLuz de estado del filtro de agua en algunos modelos Sistema de filtración de aguaRECUERDE Para quitar y volver a colocar el depósito de hieloPara limpiar su frigorífico CUIDADO DEL FRIGORÍFICOLimpieza Cómo cambiar las bombillasEs difícil abrir las puertas SOLUCIÓN DE PROBLEMASFuncionamiento del frigorífico El frigorífico no funcionaHielo y agua Temperatura y humedadLimpiador de acero inoxidable ACCESORIOSAYUDA O SERVICIO TÉCNICO Hay fugas de agua del dispensadorVotre sécurité et celle des autres est très importante TABLE DES MATIERESSECURITE DU REFRIGERATEUR DANGER AVERTISSEMENTMise au rebut adéquate de votre vieux réfrigérateur INSTRUCTIONS D’INSTALLATIONExigences demplacement AVERTISSEMENTPrise Méthode recommandée de liaison à la terreSpécifications électriques 2 Raccord de tuyau du distributeur deau Portes du réfrigérateurCharnière supérieure gaucheModèles sans distributeurs deau et de glaçons Réinstaller les portes et les charnièresDépose des portes Modèles avec distributeurs deau et de glaçonsPression de l’eau Réglage des portesSpécifications de l’alimentation en eau Raccordement à lalimentation en eauRaccordement au réfrigérateur Style UTILISATION DU REFRIGERATEUR Utilisation des commandesAchever linstallation Réglage des commandesCompartiment fraîcheur dans la porte Commande de température dans le tiroir convertibleCommande du compartiment fraîcheur dans la porte Réglage de l’humidité dans le bac à légumesLe verrouillage du distributeur sur certains modèles Machine à glaçons et bac d’entreposageDistribution de glace La lampe du distributeur sur certains modèlesTémoin lumineux de létat du filtre à eau sur certains modèles Pour retirer et réinstaller le bac dentreposage de glaçons StyleRemplacement du filtre à eau Système de filtration deauNettoyage du réfrigérateur ENTRETIEN DU REFRIGERATEURNettoyage Remplacer les ampoules d’éclairageLes portes ne ferment pas complètement DEPANNAGEFonctionnement du réfrigérateur Le réfrigérateur ne fonctionne pasIl y a une accumulation dhumidité à lintérieur Température et humiditéGlaçons et eau La température est trop élevéeL’eau du distributeur n’est pas assez froide sur certains modèles ACCESSOIRESLe distributeur d’eau ne fonctionne pas correctement De leau suinte du distributeurGarantie ASSISTANCE OU SERVICESi vous avez besoin de pièces de rechange 58  “ ” “ ”57  “ ”   n  Interior FeaturePak ½” 1.25 “ ” 2 5.0855F 13C 1⁄ 4   5⁄ 16” 10. 3. 6.35 6.35 ¼ 6.35   3”  “  24LOW HIGH  DIM ON DIM OFF 5. O 2.OFF6.  2 3         5. AUTO OFFNIGHT LIGHT Page 30 psi 207 Page G G G GGGGG G G GGGG GGGG Page Page GGGG Page Page Page GGGG G G G G G G G G G G G G U Page W10266784A Page Page Page Page Page Page Page Page Page Page Page Page
Top Page Image Contents