System Connections
Please be certain that the receiver is unplugged from the AC outlet before making any connections.
Be sure to connect the white RCA pin cords to the L(left) and the red RCA pin cords to the R(right) jacks when making connections.
Change the position of the FM indoor antenna until you get the best reception of your favorite FM stations. A 75Ω outdoor FM antenna may be used to further improve the reception.
Disconnect the indoor antenna before replacing it with the outdoor one.
Place the AM loop antenna as far as possible from the receiver, TV set, speaker cords and the AC input cord and set it to a direction for the best reception.
If the reception is poor with the AM loop antenna, an AM outdoor antenna can be used in place of the AM loop antenna. Make connections firmly and correctly. If not, poor connections can cause loss of sound, noise or damage to the receiver. If the electricity fails or the AC input cord is left unplugged for about two weeks, the memorized contents will be lost. Should this happen, memorize them again.
ENGLISH
■CONNECTING ANTENNAS
FM
(OUTDOOR ANTENNA)
FM
(INDOOR ANTENNA) | AM loop antenna |
300 ohm feeder
SUPPLIED ADAPTOR
■CONNECTING AUDIO COMPONENTS
CD player
Additional
audio component
PLAY(LINE OUT) Tape deck or
MD recorder
REC(LINE IN)
•The AUX jacks may be connected to an additional audio component such as CD player or tape deck, etc.
•Connect the TAPE MONITOR IN/OUT jacks to the PLAY(LINE OUT) / REC(LINE IN) jacks of tape deck, MD recorder or CD recorder.
•The TAPE MONITOR IN/OUT jacks may also be connected to the LINE OUT/IN jacks of an optional graphic equalizer.
■CONNECTING 7.1CH DIRECT INPUTs
SUBWOOFER CH OUT
CENTER CH OUT
SURROUND BACK CH OUT
SURROUND CH OUT
FRONT CH OUT
Decoder with 5.1
or 7.1 channel output
•Use these jacks to connect the corresponding analog outputs of a DVD player or external decoder, etc. that has 5.1 or 7.1 channel outputs.
•In case of 5.1 channel outputs, do not connect these SURROUND BACK inputs to your audio component. ( For details, refer to the operating instructions of the component to be connected.)
5