Bosch Appliances Dual-Fuel Slide-In Range installation instructions Electric Safety, Gas Safety

Page 4

Safety

It is the responsibility of the owner and the installer to determine if additional requirements and/or standards apply to specific installations.

• Installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54.

 

• The appliance must be electrically grounded in accordance with local codes

 

or, in the absence of local codes, with the National Electrical Code ANSI/

 

NFPA 70, latest edition. (In Canada, installation must be in accordance with

 

the CAN 1-B149.1 and .2 Installation Codes for Gas Burning Appliances and/

 

or local codes).

Electric Safety

• Before you plug in an electrical cord, be sure all controls are in the OFF posi-

 

tion.

 

• For appliances equipped with a cord and plug, do not cut or remove the

 

ground prong. It must be plugged into a matching grounding type receptacle

 

to avoid electrical shock. If there is any doubt as to whether the wall recepta-

 

cle is properly grounded, the customer should have it checked by a qualified

 

electrician.

 

• If required by the National Electrical Code (or Canadian Electrical Code), this

 

appliance must be installed on a separate branch circuit.

 

• Only a power-supply cord kit rated for this appliance and marked "for use with

 

ranges" shall be used.

 

• Installer - show the owner the location of the circuit breaker or fuse. Mark it for

 

easy reference.

 

• Important - Save these instructions for the local electrical inspector's use.

 

• Before installing, turn power OFF at the service panel. Lock service panel to

 

prevent power from being turned ON accidentally.

 

• Be sure your appliance is properly installed and grounded by a qualified tech-

 

nician. Installation, electrical connections and grounding must comply with all

 

applicable codes.

Gas Safety

• Install a gas shutoff valve near the appliance. It must be easily accessible in

 

an emergency.

 

• Leak testing must be conducted by the installer according to the instructions

 

in this manual.

 

• The appliance and its individual shutoff valve must be disconnected from the

 

gas supply piping system during any pressure testing at pressures in excess

 

of ½ psi (3.5 kPa).

 

• The appliance must be isolated from the gas supply piping system by closing

 

its individual manual shutoff valve during any pressure testing of the gas sup-

 

ply piping system at test pressures equal to or less than ½ psi (3.5 kPa)

 

• The minimum supply pressure must be 1" water column above the manifold

 

pressure printed on the data plate.

English 2

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Installation Instructions Table of Contents Safety Important Safety InstructionsRelated Equipment Safety Appliance Handling SafetyElectric Safety Gas SafetyPropane Gas Installation What to do if YOU Smell GASOverview InstallationTools and Parts Needed General Information Parts IncludedPreparation Remove oven door and set aside Electrical RequirementsVerify that wiring to house is adequate Electrical SpecificationsGas Requirements Important note for LP users Cabinet RequirementsRequired Clearance1 Cutout Requirements Replacing a Free-Standing ModelMounting Requirements Install Anti-Tip Bracket Prepare Walls and FloorCountertop Requirements Ventilation RecommendationsInstallation Procedure Apply Foam Tape Install Backwall TrimInstall Strain Relief Connect ElectricFour Wire Range Cord Connection Recommended Method Grounding RequirementsFour Wire Range Cord Connection Ground Strap and Wire Terminal Block Completed Three Wire Range Cord Connection Connect Gas SupplyAdjust Leveling Legs Flexible Connector MethodPlug in Range Cord Check Back of Range for Proper Installation Slide Range into OpeningRigid Pipe Method Adjust Front of Range for Proper InstallationAttach Rigid Pipe Adjust Leveling Legs Test for Gas Leaks Complete Gas ConnectionTest the Installation Yellow Tips on Outer Cones Yellow FlamesSoft Blue Flames Service Product Data PlatePage Procédure dinstallation Table des matièresSécurité Instructions de sécurité importantesSécurité relative à léquipement Sécurité pour manipuler lappareilSécurité relative aux équipements Sécurité électriqueGaz Installation du gaz propane ’IL Y a UNE Odeur DE GAZGénéralités Outils et pièces néces- saires Tableau 1 GénéralitésGénéralités Pièces comprisesPréparation Enlever la porte et la mettre de côté Exigences électriquesVérifier si le câblage résidentiel est adéquat Tableau 3 Données techniques électriquesExigences pour le gaz Remarque importante aux utilisateurs de gaz LP Exigences pour les armoires30 po 76,2 cm min Dégagements requis1 Préparation de larmoirePréparer murs et planchers Exigences de fixation Installer le dispositif anti basculeExigences de plan de travail Procédure dinstallation Apposer du ruban mousse Installer la garniture de dosseretConnexion électrique Installation du réducteur deTension Connexion de cuisinière à 4 fils méthode recommandée Connexion à 3 Fils Connexion à 4 FilsConnexion de cuisinière à 4 fils conducteur de terre et fil Bloc de bornes Connexion de lalimenta- tion en gaz Connexion à 3 fils complétéeFixer le connecteur Tableau 4 Méthode de connecteur flexibleBrancher le cordon de la cuisinière Réglage des pieds niveleursTiroir Clé Pied réglable Fixer le tuyau rigide Méthode avec tuyau rigideTableau 5 Méthode avec tuyau rigide Faire glisser la cuisinière dans louverture Régler les pieds niveleurs avantCompléter la connexion de gaz Vérifier linstallation Pointe jaune sur cône extérieur Flamme jauneFlamme bleue Avant deffectuer un appel de service Plaque signalétiqueContenidos InstalaciónSeguridad Instrucciones Importantes de SeguridadSeguridad relacionada del equipo Seguridad al manejar el aparatoSeguridad eléctrica Seguridad con el gasQUÉ Hacer Cuando Huele a GAS Instalación de gas propanoResumen InstalaciónTabla 1 Resumen Información general Partes incluidasPreparación Quitar la puerta del horno y guardarla a un lado Requerimientos eléctricosVerificar que el cableado a la casa sea apropiado Tabla 3 Especificaciones eléctricasRequerimientos de gas Nota importante para usuarios de gas LP Figura 5 Requerimientos del recorte instalación típica Requerimiento para espacio libre1 Figura 7 Preparación para los gabinetesRequerimientos para cubiertas Preparar las paredes y los pisosRequerimientos de montaje Instalar el soporte antivolcadura Procedimiento de Instalación Conexión eléctrica Instalar el prensacablesConexión DE 3 Hilos Conexión DE 4 Hilos Conexión del cable con cuatro hilos método recomendadoFigura 15 Conexión del cable de 4 hilos, continuación Figura 16 Bloque de terminales Conectar el suministro de gas Figura 19 Ubicación de la conexión del gasFijar la manguera Tabla 4 Método con manguera flexibleEnchufar el cable de la estufa Ajustar las patas de nivelaciónDeslizar la estufa a la abertura Figura 21 Ajustar los soportes de las patas delanterasFijar el tubo rígido Método con tubo rígidoTabla 5 Método con tubo rígido Consejo Probar si hay fugas de gas Terminar la conexión de gasProbar si hay un encendido apropiado Probar la instalaciónProbar las características de llamas con bajo calor Probar las características de llamas con alto calor Llamas amarillasPuntas amarillas en conos exteriores Llamas azules suavesServicio Placa con datos del producto

Dual-Fuel Slide-In Range specifications

The Bosch Appliances Dual-Fuel Slide-In Range is a sophisticated addition to modern kitchens, combining the best of both gas and electric cooking technologies. Designed for optimal performance and style, this range seamlessly blends functionality with aesthetic appeal, making it a popular choice among home chefs and culinary enthusiasts.

One of the standout features of the Bosch Dual-Fuel Slide-In Range is its dual-fuel capability. It utilizes a gas cooktop, providing precise heat control and instant flame adjustments, making it ideal for tasks that require quick temperature changes, such as searing or sautéing. The electric oven, on the other hand, ensures even baking and roasting, powered by its European Convection system. This technology uses a fan to circulate hot air, resulting in uniform cooking and consistent results across all baking and roasting tasks.

The range also features a sleek touch control panel, which enhances the user experience with its intuitive interface. This panel allows for easy temperature adjustments and timer settings, making the cooking process more streamlined. Additionally, the continuous cast-iron grates provide a sturdy cooking surface that allows for easy movement of pots and pans, enhancing the versatility of the cooktop.

Another notable characteristic of this range is its spacious oven capacity. With a generous interior, the Bosch Dual-Fuel Slide-In Range accommodates larger meals with ease, making it perfect for family gatherings or entertaining guests. The range also includes a self-cleaning option, which simplifies the maintenance process, allowing users to spend more time enjoying their culinary creations rather than cleaning.

Safety features are also a priority in the design of this appliance. The Bosch Dual-Fuel Slide-In Range includes a flame failure safety device, ensuring that the gas flow is automatically shut off if the flame goes out. This feature provides peace of mind for home cooks.

Overall, the Bosch Appliances Dual-Fuel Slide-In Range stands out as an exemplary kitchen appliance that balances style, performance, and safety. Its advanced technologies, elegant design, and practical features make it an attractive option for anyone looking to elevate their cooking experience. Whether you are an aspiring chef or a casual cook, this range offers the versatility and functionality needed to create delicious meals with confidence.
Top Page Image Contents