Bosch Appliances Dual-Fuel Slide-In Range Remove oven door and set aside, Electrical Requirements

Page 8

Installation

Remove oven door and set aside.

WARNING:

When removing the door:

• Make sure oven is cool and power to the oven has been turned off before removing the door. Failure to do so could result in electrical shock or burns.

•The oven door is heavy and fragile. Use both hands to remove the oven door. The door front is glass. Handle carefully to avoid breaking.

•Grasp only the sides of the oven door. Do not grasp the handle as it may swing in your hand and cause damage or injury.

•Failure to grasp the oven door firmly and properly could result in personal injury or product damage.

•To avoid injury from hinge bracket snapping closed, be sure that both levers are securely in place before removing door. Also, do not force door open or closed - the hinge could be damaged and injury could result.

1.Be sure to read the above WARNING before attempting to remove oven door.

2.Open the door all the way.

3.Flip levers on hinges (one on each side) toward you.

Figure 3: Hinge Positions

4. Close the door until it stops. It will be about half- way open.

5. Holding the door firmly on both sides and using

both hands, pull the door straight out of the hinge slots. Hold firmly, the door is heavy.

6. Place the door in a stable location.

Electrical Requirements

Refer to data plate for more information. See “Product Data Plate” on page 24 for

 

data plate location.

 

We recommend that the range be installed with a power cord set (not supplied).

 

The electrical rating of the power cord set must be 120/240 volt, 30 amperes

 

minimum. The power cord set shall be marked “For Use with Ranges.” Always

 

use a new power cord.

 

Note:

 

In Canada, the range is shipped from the factory with the range cord

 

already installed.

English 6

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Installation Instructions Table of Contents Safety Important Safety InstructionsRelated Equipment Safety Appliance Handling SafetyElectric Safety Gas SafetyPropane Gas Installation What to do if YOU Smell GASTools and Parts Needed InstallationOverview Preparation Parts IncludedGeneral Information Remove oven door and set aside Electrical RequirementsGas Requirements Electrical SpecificationsVerify that wiring to house is adequate Important note for LP users Cabinet RequirementsRequired Clearance1 Cutout Requirements Replacing a Free-Standing ModelMounting Requirements Install Anti-Tip Bracket Prepare Walls and FloorCountertop Requirements Ventilation RecommendationsInstallation Procedure Apply Foam Tape Install Backwall TrimInstall Strain Relief Connect ElectricFour Wire Range Cord Connection Recommended Method Grounding RequirementsFour Wire Range Cord Connection Ground Strap and Wire Terminal Block Completed Three Wire Range Cord Connection Connect Gas SupplyPlug in Range Cord Flexible Connector MethodAdjust Leveling Legs Check Back of Range for Proper Installation Slide Range into OpeningAttach Rigid Pipe Adjust Front of Range for Proper InstallationRigid Pipe Method Adjust Leveling Legs Test for Gas Leaks Complete Gas ConnectionTest the Installation Soft Blue Flames Yellow FlamesYellow Tips on Outer Cones Service Product Data PlatePage Procédure dinstallation Table des matièresSécurité Instructions de sécurité importantesSécurité relative à léquipement Sécurité pour manipuler lappareilGaz Sécurité électriqueSécurité relative aux équipements Installation du gaz propane ’IL Y a UNE Odeur DE GAZGénéralités Outils et pièces néces- saires Tableau 1 GénéralitésPréparation Pièces comprisesGénéralités Enlever la porte et la mettre de côté Exigences électriquesExigences pour le gaz Tableau 3 Données techniques électriquesVérifier si le câblage résidentiel est adéquat Remarque importante aux utilisateurs de gaz LP Exigences pour les armoires30 po 76,2 cm min Dégagements requis1 Préparation de larmoireExigences de plan de travail Exigences de fixation Installer le dispositif anti basculePréparer murs et planchers Procédure dinstallation Apposer du ruban mousse Installer la garniture de dosseretTension Installation du réducteur deConnexion électrique Connexion de cuisinière à 4 fils méthode recommandée Connexion à 3 Fils Connexion à 4 FilsConnexion de cuisinière à 4 fils conducteur de terre et fil Bloc de bornes Connexion de lalimenta- tion en gaz Connexion à 3 fils complétéeFixer le connecteur Tableau 4 Méthode de connecteur flexibleBrancher le cordon de la cuisinière Réglage des pieds niveleursTiroir Clé Pied réglable Tableau 5 Méthode avec tuyau rigide Méthode avec tuyau rigideFixer le tuyau rigide Faire glisser la cuisinière dans louverture Régler les pieds niveleurs avantCompléter la connexion de gaz Vérifier linstallation Flamme bleue Flamme jaunePointe jaune sur cône extérieur Avant deffectuer un appel de service Plaque signalétiqueContenidos InstalaciónSeguridad Instrucciones Importantes de SeguridadSeguridad relacionada del equipo Seguridad al manejar el aparatoSeguridad eléctrica Seguridad con el gasQUÉ Hacer Cuando Huele a GAS Instalación de gas propanoTabla 1 Resumen InstalaciónResumen Preparación Partes incluidasInformación general Quitar la puerta del horno y guardarla a un lado Requerimientos eléctricosRequerimientos de gas Tabla 3 Especificaciones eléctricasVerificar que el cableado a la casa sea apropiado Nota importante para usuarios de gas LP Figura 5 Requerimientos del recorte instalación típica Requerimiento para espacio libre1 Figura 7 Preparación para los gabinetesRequerimientos de montaje Instalar el soporte antivolcadura Preparar las paredes y los pisosRequerimientos para cubiertas Procedimiento de Instalación Conexión eléctrica Instalar el prensacablesConexión DE 3 Hilos Conexión DE 4 Hilos Conexión del cable con cuatro hilos método recomendadoFigura 15 Conexión del cable de 4 hilos, continuación Figura 16 Bloque de terminales Conectar el suministro de gas Figura 19 Ubicación de la conexión del gasFijar la manguera Tabla 4 Método con manguera flexibleEnchufar el cable de la estufa Ajustar las patas de nivelaciónDeslizar la estufa a la abertura Figura 21 Ajustar los soportes de las patas delanterasTabla 5 Método con tubo rígido Método con tubo rígidoFijar el tubo rígido Consejo Probar si hay fugas de gas Terminar la conexión de gasProbar las características de llamas con bajo calor Probar la instalaciónProbar si hay un encendido apropiado Probar las características de llamas con alto calor Llamas amarillasPuntas amarillas en conos exteriores Llamas azules suavesServicio Placa con datos del producto

Dual-Fuel Slide-In Range specifications

The Bosch Appliances Dual-Fuel Slide-In Range is a sophisticated addition to modern kitchens, combining the best of both gas and electric cooking technologies. Designed for optimal performance and style, this range seamlessly blends functionality with aesthetic appeal, making it a popular choice among home chefs and culinary enthusiasts.

One of the standout features of the Bosch Dual-Fuel Slide-In Range is its dual-fuel capability. It utilizes a gas cooktop, providing precise heat control and instant flame adjustments, making it ideal for tasks that require quick temperature changes, such as searing or sautéing. The electric oven, on the other hand, ensures even baking and roasting, powered by its European Convection system. This technology uses a fan to circulate hot air, resulting in uniform cooking and consistent results across all baking and roasting tasks.

The range also features a sleek touch control panel, which enhances the user experience with its intuitive interface. This panel allows for easy temperature adjustments and timer settings, making the cooking process more streamlined. Additionally, the continuous cast-iron grates provide a sturdy cooking surface that allows for easy movement of pots and pans, enhancing the versatility of the cooktop.

Another notable characteristic of this range is its spacious oven capacity. With a generous interior, the Bosch Dual-Fuel Slide-In Range accommodates larger meals with ease, making it perfect for family gatherings or entertaining guests. The range also includes a self-cleaning option, which simplifies the maintenance process, allowing users to spend more time enjoying their culinary creations rather than cleaning.

Safety features are also a priority in the design of this appliance. The Bosch Dual-Fuel Slide-In Range includes a flame failure safety device, ensuring that the gas flow is automatically shut off if the flame goes out. This feature provides peace of mind for home cooks.

Overall, the Bosch Appliances Dual-Fuel Slide-In Range stands out as an exemplary kitchen appliance that balances style, performance, and safety. Its advanced technologies, elegant design, and practical features make it an attractive option for anyone looking to elevate their cooking experience. Whether you are an aspiring chef or a casual cook, this range offers the versatility and functionality needed to create delicious meals with confidence.
Top Page Image Contents