Southbend STRE-3D owner manual Check the Installation, Check Steamer Operation

Page 18

INSTALLATION

STRATOSTEAM COUNTERTOP STEAMER

STEP 6: CHECK THE INSTALLATION

Check the installation of each steamer, as follows:

1.Check that all screws and bolts are tightened.

2.Check that the electrical, water, and drain connections have been made correctly.

3.Check that the steamer is level. If not, adjust the legs (or level the countertop surface).

4.Check that the appropriate minimum clearances are satisfied (see page 4).

5.Check the door for proper alignment, and that it opens and closes properly.

6.Check that there is sufficient clearance in front of the steamer to open the door and to pull out the pans.

7.Wipe clean all surfaces.

STEP 7: CHECK STEAMER OPERATION

Check the operation of each steamer, as follows:

1.Turn on the electric power supply and the water supply.

2.Move the ON/OFF lever to the “ON” position and check that the Power light comes on.

3.Check that the timer and buzzer operate correctly.

4.Open the door and check that water is entering the cavity (NOTE: the fill rate is slow).

5.Wait four minutes, then check that some water has covered the bottom of the cavity.

6.Depress the door-switch actuator rod and listen for an audible “click.” Release the door-switch actuator rod and listen for another audible “click.” (The clicks indicate that the contactor is functioning properly.)

7.Check that steam is escaping from the vent at the top left rear corner of the steamer.

8.Move the ON/OFF lever to the “OFF” position and check that the Power light goes out. Also check that the water is draining correctly into the drain, and that the steamer completely drains.

STEP 8: SHUT-DOWN AND WIPE-CLEAN STEAMER

Complete the installation by leaving the steamer ready for customer use:

1.Allow the steamer to cool.

2.Wipe clean all surfaces.

3.Unless the steamer is to be placed in service immediately, turn off the electric power supply and water supply.

4.Make sure that a copy of this manual will be available to the people who will operate and maintain the steamer.

PAGE 18 OF 48

OWNER’S MANUAL 1185184

Page 17 Page 19
Image 18
Page 17 Page 19
Contents StratoSteam Safety Precautions Introduction Location of Serial PlatesSpecifications DimensionsClearances Dimensions Right Side ViewElectrical Requirements Water RequirementsDrain Requirements Startup Troubleshooting by OperatorOperation OperationControls Cooking TipsSuggested Cooking Times Periodic DE-LIMING AS Needed Cleaning & MaintenanceDaily Cleaning and Maintenance STAINLESS-STEEL SurfacesStratosteam Countertop Steamer Cleaning & Maintenance Installation UnpackingAttach Legs Attach LegsMounting on Cabinet Base Installation on CountertopAttach to Countertop Stacking TWO SteamersLocation of Connections and Vents Drain ConnectionWater Drain Water ConnectionWater Connection Electrical Connection Electrical ConnectionCheck the Installation SHUT-DOWN and WIPE-CLEAN SteamerCheck Steamer Operation Service Troubleshooting FLOWCHARTS, PROCEDURES, and Wiring DiagramsHOW the Steamer Operates How the Steamer Operates Steamer Not Heating Up, Power Light Is Not Lit Disconnect Power AT Circuit BreakerCheck that water-supply pressure is adequate Buzzer Does Not Come On When Timer Runs Out Disconnect Power AT Circuit Breaker Heating Cartridge Check at ContactorPower Switch Check Contactor Check Timer and Buzzer Check Door Switch Check High-Limit Thermostats Check Water-Level-Control Sensor Check Water Solenoid Check Wiring Diagram for 208/220/240 Volt Models Wiring Diagram for 480 Volt Models Parts Diagram PartsStructural Parts See parts list on previous Door Assembly Parts Door Switch Parts Control Panel Parts Heating Cartridges, Thermostats, and Contactor Parts Water Train Parts Water-Train Parts Cabinet Base Parts Cabinet-Base Parts Stratosteam Countertop Steamer Stratosteam Countertop Steamer StratoSteam Countertop Steamer Models STRE-3D and STRE-5D
Top Page Image Contents