Briggs & Stratton 205378GS manual Assembly, Unpack Trash Pump, Add Engine Oil, Add Fuel

Page 7

Assembly

Read entire operator’s manual before you attempt to assemble or operate your new trash pump.

Your trash pump requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.

If you have any problems with the assembly of your trash pump, please contact your local Briggs & Stratton service center. If calling for assistance, please have the model, revision, and serial number from the data tag available. See Controls section for data tag location.

Unpack Trash Pump

1.Remove the parts bag, accessories, and inserts included with trash pump.

2.Open carton completely by cutting each corner from top to bottom.

3.Ensure you have all included items prior to assembly.

Items in the carton include:

• Trash pump

• Parts bag (which includes the following):

This operator’s manual

Owner’s registration card

Strainer basket and barb

Hose barb (2)

Barb cuff (2)

Rubber seal (2)

Hose clamp (3)

To prepare your trash pump for operation, you will need to perform these tasks:

1.Fill out and send in registration card.

2.Add oil to engine crankcase.

3.Add fuel to fuel tank.

4.Attach suction hose.

5.Connect discharge hose (optional).

6.Move trash pump to safe operating location.

7.Prime the trash pump.

8.Locate strainer basket into water source.

Add Engine Oil

1.Place trash pump on a flat, level surface.

2.Clean area around oil fill and remove yellow oil fill cap . NOTE: See Oil Recommendations in Maintenance section.

3.Using oil funnel (optional), slowly pour engine oil into oil fill opening to the point of overflowing.

NOTICE

Improper treatment of trash pump can damage it and shorten its life.

DO NOT attempt to crank or start the engine before it has been properly serviced with the recommended oil. This may result in an engine failure.

4.Replace oil fill cap and fully tighten.

Add Fuel

Fuel must meet these requirements:

Clean, fresh, unleaded gasoline.

A minimum of 87 octane/87 AKI (91 RON). High altitude use, see High Altitude.

Gasoline with up to 10% ethanol (gasohol) or up to 15% MTBE (methyl tertiary butyl ether) is acceptable.

NOTICE

Avoid trash pump damage.

Failure to follow Operator’s Manual for fuel recommendations voids warranty.

DO NOT use unapproved gasoline such as E85.

DO NOT mix oil in gasoline.

DO NOT modify engine to run on alternate fuels.

To protect the fuel system from gum formation, mix in a fuel stabilizer when adding fuel. See Storage. All fuel is not the same. If you experience starting or performance problems after using fuel, switch to a different fuel provider or change brands. This engine is certified to operate on gasoline. The emission control system for this engine is EM (Engine Modifications).

WARNING

Fuel and its vapors are extremely flammable and explosive.

Fire or explosion can cause severe burns or death.

WHEN ADDING FUEL

Turn trash pump OFF and let it cool at least 2 minutes before removing fuel cap. Loosen cap slowly to relieve pressure in tank.

Fill fuel tank outdoors.

DO NOT overfill tank. Allow space for fuel expansion.

If fuel spills, wait until it evaporates before starting engine.

Keep fuel away from sparks, open flames, pilot lights, heat, and other ignition sources.

DO NOT light a cigarette or smoke.

1.Clean area around fuel fill cap, remove cap.

2.Slowly add regular unleaded fuel to fuel tank. Fill to red level indicator (A). Be careful not to overfill.

A

3.Install fuel cap and let any spilled fuel evaporate before starting engine.

7

Image 7
Contents Operator’s Manual Date Purchased Where to Find UsTrash Pump EngineTable of Contents Equipment Description Operator SafetySafety Rules Hazard Symbols and MeaningsUnintentional sparking can result in fire or electric shock Use of trash pump can create puddles and slippery surfacesContact with muffler area can result in serious burns Add Fuel AssemblyUnpack Trash Pump Add Engine OilConnect Suction Hose to Pump Attach Suction HoseConnect Discharge Hose Optional High AltitudePump Chamber Be sure to fill with water before starting Features and ControlsC D EF MN P QS T Move Trash Pump to Safe Operating Location What is Head?Operation Safe Operating ConsiderationsSuction Head Feet 8m Maximum Total HeadFeet 35.6m MaximumMove choke lever D to Choke Position Starting the Trash PumpStopping the Trash Pump Move engine speed lever C to FastAfter Each Use Flush and Drain Trash Pump and Clean the ImpellerEngine Maintenance MaintenanceMaintenance Schedule Trash Pump MaintenanceChanging Engine Oil Service Air CleanerChecking Oil Level Adding Engine OilAir Cooling System Service Spark PlugClean Spark Arrester Screen Loosen screw a and tilt cover B downStorage Problem Cause Correction TroubleshootingLimited Warranty Maximum Head Product SpecificationsCommon Service Parts ModelManual del Operario Fecha de compra Dónde encontrarnosBomba de Residuos MotorCaracterísticas y mandos Operando Resolución de Problemas GarantíaSeguridad de Operario MontajeDescripción del equipo Seguridad de OperarioReglas de seguridad Cuando Opere EL Equipo Cuando Pruebe LA Bujía DEL MotorCuando Anada Combustible O Vacíe EL Depósito Cuando Ponga EN Funcionamiento EL EquipoAviso Agregue combustible MontajeDesembalaje la bomba de residuos Agregar aceite al motorCuando Anada Combustible EL Depósito Fijación de la manguera de aspiraciónGran altitud Conexión de la manguera de aspiración a la bombaConexión de la manguera a la cesta del filtro Conexión de la manguera de descarga opcionalArrancador de retroceso Permite arrancar el motor Características y mandosEspacio libre y circulación de aire OperandoConsideraciones para un uso seguro Colocación de la bomba de residuos en una posición seguraColocación de la cesta del filtro en la fuente de agua Cebado de la bomba de residuosPuesta en marcha de la bomba de residuos Mueva poco a poco la palanca estranguladora hacia la Parada de la bomba de residuosEl motor podría petardear, incendiarse o dañarse Lave y vacíe la bomba de residuos y limpie la turbina Después de cada usoMantenimiento del motor MantenimientoPlan de mantenimiento Mantenimiento del bomba de residuosCambio de aceite del motor Aceite Recomendaciones sobre el aceiteComprobación del nivel de aceite Adición de aceite del motorLimpieza de la pantalla apagachispas Revisión del filtro de aireAfloje el tornillo D y quite la cubierta E Revisión de la bujíaInstrucciones de almacenamiento a largo plazo AlmacenamientoSistema de refrigeración de aire Revisión de la holgura de las válvulasLas cubiertas para almacenamiento pueden ser inflamables Aceite el diámetro interior del cilindroBomba de residuos Otras sugerencias para el almacenamientoResolución de Problemas Garantía Limitada Altura máxima Especificaciones del productoServicio común despide ModeloManuel d’utilisation Date d’achat Où nous trouverPompe à résidus MoteurEntretien Fonctions et commandes OpérationSécurité de l’opérateur AssemblageRègles de sécurité Symboles de danger et moyensSécurité de l’opérateur Description de l équipementUnintentional peut résulter dans feu ou électrique Usage de la pompe à résidus peut créer puddles et glissantAvis Ajoutez de lessence AssemblageDéballage du pompe à résidus Ajoutez de lhuile à moteurLors DE Lajout DU Carburant Fixation du boyau daspirationAltitude élevée Branchement du boyau daspiration à la pompeFixation du boyau daspiration au panier-filtre Branchement du boyau dévacuation facultatifLanceur Utilisé pour le démarrage du moteur Fonctions et commandesArticle non montrés Dégagements et mouvement de lair Déplacement de la pompe vers un emplacement sécuritaireOpération Pour un fonctionnement sécuritaireReplacez le bouchon de la pompe Amorçage de la pompe à résidusDémarrage de la pompe à résidus Enlevez le bouchon fixé sur le dessus de la pompeRapide Arrêt de la pompe à résidusAprès chaque utilisation Entretien du moteur EntretienCalendrier dentretien Entretien du pompe à résidusVidange de lhuile moteur Huile Recommandations relatives à l’huileVérification du niveau dhuile Ajout d’huileNettoyage de lécran pare-étincelles Entretien du filtre à airDévissez la vis D et ouvrez le couvercle E Entretien de la bougie dallumageVérification du jeu des soupapes Système de refroidissement à airEntreposage Dépannage Garantie Limitée Hauteur maximale Caractéristiques du produitPièces d’entretien courant Modèle