WARNING
Starter cord kickback (rapid retraction) can result in bodily injury. Kickback will pull hand and arm toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains could result.
Keep hands and body clear from discharge of pump.
•When starting engine, pull cord slowly until resistance is felt and then pull rapidly to avoid kickback.
•Secure discharge hose to avoid whipping.
WARNING
Contact with muffler area can result in serious burns.
Exhaust heat/gases can ignite combustibles, structures or damage fuel tank causing a fire.
•DO NOT touch hot parts and AVOID hot exhaust gases.
•Allow equipment to cool before touching.
•Keep at least 5 feet (1.5 m) of clearance on all sides of trash pump including overhead.
WARNING
Starter and other rotating parts can entangle hands, hair, clothing, or accessories.
•NEVER place hands or body parts inside of running pump or hoses.
•NEVER operate trash pump without protective housing or covers.
•DO NOT wear loose clothing, jewelry or anything that may be caught in the starter or other rotating parts.
•Tie up long hair and remove jewelry.
CAUTION
Excessively high operating speeds increase risk of injury and damage to trash pump.
Excessively low speeds impose a heavy load.
•DO NOT tamper with governed speed.
•DO NOT modify trash pump in any way.
•DO NOT allow unqualified persons or children to operate or service trash pump.
NOTICE
Improper treatment of trash pump can damage it and shorten its life.
•If you have questions about intended use, ask dealer or contact qualified service center.
•Be sure pump chamber is filled with water before starting the engine. Never run pump without priming.
•Use a
•Use trash pump only for intended uses.
•Pumping sea water, beverages, acids, chemical solutions, or any other liquid that promotes corrosion can damage the pump.
•Ensure all connections are air tight.
•DO NOT obstruct the suction or discharge hose in any way.
•NEVER operate pump without strainer basket connected to end of suction hose.
•DO NOT exceed suction head maximum of 8m (25 ft.) and total head of 35.6m (117 ft.). Use shortest suction head possible (see page 11).
•NEVER allow vehicles to drive over hoses. If a hose must be positioned across a roadway, use planking on each side of hose to allow vehicles to pass over without obstructing or collapsing hose.
•Anchor pump to avoid “walking” or equipment movement, especially if located near a ditch or edge of open ravine. The equipment could fall in.
•Keep equipment away from edge of river or lake where it could cause the bank to collapse.
•DO NOT insert any objects through cooling slots.
•NEVER operate units with broken or missing parts, or without protective housing or covers.
•DO NOT
•NEVER move machine by pulling on hoses. Use frame on unit.
•Check fuel system for leaks or signs of deterioration, such as chafed or spongy hose, loose or missing clamps, or damaged tank or cap. Correct all defects before operating trash pump.
•This equipment is designed to be used with Briggs & Stratton Power Products authorized parts ONLY. If equipment is used with parts that DO NOT comply with minimum specifications, user assumes all risks and liabilities.
6 | BRIGGSandSTRATTON.COM |