High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To remain emissions compliant, high altitude adjustment is required. Operation without this adjustment will cause decreased performance, increased fuel consumption, and increased emissions. See an Authorized Briggs & Stratton dealer for high altitude adjustment information. Operation of the engine at altitudes below 2,500 feet (762 meters) with the high altitude kit is not recommended.
Attach Suction Hose
You will need the following tool to install the hoses to the trash pump:
• 1/4" or 6mm standard screwdriver
Connect Suction Hose to Pump
Use a commercially available hose. The suction hose must be reinforced with a
1.Slide barb cuff (A) over hose barb (B). Insert rubber seal (C) into end of barb cuff.
A
BC
2.Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely.
3.Slide hose clamp (D) over end of hose (E). Slide suction hose onto hose barb (F). Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
Attach Suction Hose to Strainer Basket
Slide hose clamp over hose. Attach open end of suction hose to strainer hose barb. Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
Connect Discharge Hose (Optional)
If desired, use a commercially available hose. DO NOT use a hose with an inside diameter smaller than the pump’s discharge port size.
1.Slide barb cuff over hose barb. Insert rubber seal into end of barb cuff as shown earlier.
2.Screw hose barb assembly onto pump in clockwise rotation until hose barb assembly is tightened securely.
3.Slide hose clamp over end of discharge hose. Slide discharge hose onto hose barb. Tighten hose clamp securely using a standard 1/4” (6mm) screwdriver.
E D
F
8 | BRIGGSandSTRATTON.COM |