Delay Hours
Use this option to run your dishwasher during
To delay the start
1.Select a wash cycle and options.
2.Press the 4 Hour Delay button.
3.Press START/RESUME and firmly close the door within 3 seconds.
NOTE: Anytime the door is opened (such as, to add a dish), the START/RESUME button must be pressed again, within 3 seconds of closing the door, to resume the delay countdown.
Control Lock Option |
|
Use the Control Lock option to avoid unintended use of the dishwasher between cycles. When the lock icon and |
|
LOCKED is lit, all buttons are disabled. The dishwasher door can still be opened/closed while the controls are locked. |
|
To turn on the Lock |
|
Press and hold HEATED DRY for 4 seconds. The lock icon and LOCKED will light up. If you press any pad while your |
|
dishwasher is locked, the light flashes 4 times. |
|
NOTE: The dishwasher cannot run if the control is locked. |
|
To turn off the Lock |
|
Press and hold HEATED DRY for 4 seconds. The light turns off. | _ |
1.Open the door slightly to stop the cycle. Wait for the spraying action to stop before completely opening the door.
2.Press CANCEL/DRAIN button once. The Cancel/Drain light will light up.
3.Close the door within 3 seconds. The dishwasher starts a drain cycle (if water remains in bottom of dishwasher). Let the dishwasher drain completely. The Cancel/Drain light turns off after 2 minutes.
You can interrupt a cycle and restart your dishwasher from the beginning using the following procedure.
1.Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2.Check that detergent dispenser cover is still closed. If cover is open, you will need to refill the detergent dispenser before restarting your new cycle.
3.Press CANCEL/DRAIN twice to reset the control.
4.Select new cycles and options.
5.Press START/RESUME and firmly close the door within 3 seconds.
NOTE: If the door is not closed within 3 seconds of pressing Start/Resume, press START/RESUME again.
1.Open the door slightly to stop the cycle. Wait for the spraying action to stop, then open the door completely.
2.Check whether the detergent dispenser cover is still closed. If it is open, the wash cycle has already started and adding a dish is not recommended.
3.If detergent has not yet been used (detergent dispenser cover is closed), you may add a dish.
4.Press START/RESUME and firmly close the door within 3 seconds.
19