Multiquip DCA85usJ2 manual Shutdown Codes, Bachlight Adjustment

DIAGNOSTIC DISPLAY

Shutdown Codes

1.During normal operation the single or four parameter screen will be displayed

				98%	1000 RPM
0			3000	LOAD RPM	ENG RPM
	1500
	1800 RPM
				14.2	57 PSI
ENG RPM		COOL TEMP		BATT VOLT	OIL PRES

5.Touching the “Enter Button” once again will hide the fault and return the screen to the single or four parameter display.

1 of x SHUTDOWN

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

2.When the diagnostic display receives a severe fault code from an engine control unit the single or four parameter screen will be replaced with the “Shutdown” message.

1 of x SHUTDOWN

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

6.The Single or Four parameter screen will display the fault icon until the fault condition is corrected. NOTE: Ignoring active fault codes could result in severe engine damage.

				!	98%		1000 RPM
0	1500		3000		LOAD RPM		ENG RPM
	1800 RPM					!
					14.2		57 PSI
ENG RPM		COOL TEMP!			BATT VOLT		OIL PRES	!

3.To acknowledge and “Hide” the fault and return to the single or four parameter display touch the “Enter Button

”

1 of x SHUTDOWN

SPN110 FMI10

HIGH COOLANT TEMP

MORE HIDE

Bachlight Adjustment

1.Starting at the single or four engine parameter display touch the “Menu Button”.

				!	98%		1000 RPM
0	1500		3000		LOAD RPM		ENG RPM
	1800 RPM					!
					14.2		57 PSI
ENG RPM		COOL TEMP!			BATT VOLT		OIL PRES

4. . The display will return to the single or four parameter display, but the display will contain the “Shut Down” icon. Touching the “Enter Button” will redisplay the hidden fault.

				!	98%		1000 RPM
0	1500		3000
	1800 RPM				LOAD RPM		ENG RPM
						!
		COOL TEMP!			14.2		57 PSI
ENG RPM
					BATT VOLT		OIL PRES

2.The main menu will pop up on the display. Use the “Arrow Buttons” to scroll through the menu until the “Adjust Backlight” is highlighted.

GO TO 1-UP DISPLAY

STORED CODES

ENGINE CONFG

SETUP 1-UP DISPLAY

SETUP-4-UP DISPLAY

SELECT UNITS

ADJUST BACKLIGHT

DCA85USJ2 60 HZ GENERATOR • OPERATION AND PARTS MANUAL — REV. #1 (03/22/11) — PAGE 25